Antrader 2 Pcs Glass Cabinet Door Hinges, Wine Cabinet Clamps Display Gate Hinges, Zinc Alloy Matte Black, No Need to Drill Hole

these hinges are a great replacement for the Ender 6 3D printer front door if yours break off like the one did on mine..

I had to slightly inlay them , but with that they fit. It was close.

I broke the door hinge on my ender 6 and these are an exact match. I had to reuse the screws that bolt it to the printer frame since these are really wood cabinet hinges but that was not a problem.

The henge broke in to two when it installed to glass.

One of the hinges on my Ender-6 broke, so I replaced it with one of these. They're exactly the same hinges.

The Hinges were a perfect fit for the Creality Ender 6

Strong hinges... I used them for a 1/4" acrylic door on a display case. Nice flat black finish.

Just installed a couple of glass panes using these door hinges. The hinges appear to be solid, with small rubber contact points on the machine screws that affix to the glass. So far, so good. But the wood screws that were provided to mount the hinge are really weak. I used a drill driver on low torque setting and two of the four screws just sheared in two. This was into pine where there was already a pre-existing hole so there was no over-torqueing involved. I'm replacing all of the screws as I don't trust them to hold the weight of the glass for long . But I'm also perturbed because there are broken screws embedded in two of the holes which is now forcing me to have to relocate the hinges.