KEMIMOTO UTV Harness Pass-through Bezel, Seat Belt Pass Through Bezel Insert Compatible with Polaris RZR XP1000 900 S XC General

The directions were good. There are a few you tube videos that also helped with the install. Definitely use a Dremel to cut the back of the seat. Using a sharp knife will not work. They said not to trim any foam on my model, however I found it necessary to do so for getting the bezels to marry.

A little hard to install the first one but after that, they were easy. Watch some on line videos before you start, there’s plenty of them online. I used a Dremel with a small cutoff wheel, a box cutter with some fresh blades, a long “click” knife, and a 1” hole saw. The trick with the hole saw was to shorten the pilot drill bit and drill easy. Fist one took 2 hours, second one 45 min and the last two took 15 min.

They do their job. Installation seems a little odd, and I'm pretty sure instructions coul've have been written a bit less ambiguous. They are apparently actually a universal fit, so they dont fit the contours exactly, but overall they are pretty good. For install, i'd recomend a body saw or Dremel Multimatic or similar. I managed the cut with an oscillating multitool.

A little difficult to install with getting everything cut in correctly, but well worth it! We will definitely be ordering again if we get another razor.

Quedó perfecto

Tight fit works great

These inserts are the perfect addition to the stock RZR seats if you are planning on adding 4 point harnesses. Initially the installation seemed a bit intimidating because you essentially have to cut up your factory seats by cutting out some plastic and slicing the fabric. The first one you do will most likely have the most trial and error and time spent figuring out how to make things work and fit right. My suggestion to anyone who is planning on buying these or has already bought them is to invest in a Dremel with cutting discs. I did not have a Dremel and ended up doing the majority of my cutting with a angle grinder. Due to the size of the angle grinder blade I was not able to make specific precise cuts so I relied on a hand drill with grinding attachments to finish out some of the corners. Once you get the hang of it it is very easy and seats 2-4 were a breeze. Overall these inserts are much more cost effective than spending a lot of money on aftermarket seats that come with harness pass throughs from the factory.

The way this was designed makes it look like it was original once installed. It fit perfectly and the stencil it came with made it much easier to cut out. The value for the money is great