Highwild 6-Volt Solar Panel Charger for 6V Feeder Battery - Deer Feeder Outdoor Waterproof Solar Charger with Mounting Hardware

Outstanding product and the quality is on point. I have had this unit hooked up to a deer feeder for 7 years now and it still works great! Rodent proof and it works for its intended purpose.

This solar cell is being used to keep a 6 volt battery charged. I like that this unit is well built and has a bracket that attached easily to a pole clamp at the right angle for good sun concentration. The wires were insulated in a kind of romex sleeve and was easy to run into the battery compartment of the feeder and stay sealed from moisture. Since my rechargeable battery hasn't drained as of yet I will assume it to be working properly through my cheap 6 volt charge controller. It's attached to a small low profile deer feeder in the backyard that I modified from using four AAA batteries at 6 volts. I took the batteries out and soldered two wires from + and - to a charge controller. I placed it inside the feeder along with a rechargeable 6 volt battery. I placed this 6 volt solar cell on the outside facing South at about 45 degrees elevation. So far, it seems to be compatible with my charge controller. I will put a voltmeter on the battery to see if it is staying properly charged and update this rating if necessary.

Easy installation and keeps battery charged.

Works well on my 6v battery for my deer feeder. Keeps the battery charged. Be sure and mount it high on feeder and tie the cord up. I had a buck get his antlers wrapped around the cord and yanked the charger off. It still works so I guess that proves it’s durable.

Obviously, on something like this, only time will tell as to how good it actually is. However, it appears to be well made. The metal cable shielding is a must to keep squirrels from eating the wires. I really like the fact that they put the 1/4 inch battery terminals on the wires instead of alligator clips. I have bought several other models in the past (12 volt) and the alligator clips they put on are larger than the sleeves used to clamp down the cable, so there is no way to put a sleeve on either side of the wall of the feeder to secure it into place. These were great. They just slipped through the hole and they plugged directly and securely onto the battery without the worry of them slipping off, the way alligator clips do.

Good feeder replacement panel

I haven't installed it yet, but it is as described. Would buy again.

Don’t come with batteries or charger

Excelente

La calidad de siempre