Butler Creek Tini-Bikini Pistol Scope Cover

I have bought two of these. One for a 9 inch Burris Handgun scope. One for a 10 inch Burris handgun scope. The "caps" on the ends of these are just right for the size of the ends of the scopes. I would not want much bigger, but they are medium to small objectives as they go in scope world. To put them on the 9-inch scope takes some stretching. The 10-inch one takes even more, perhaps bordering on a little too much. But, they go on and they are snug and secure. They protect my lenses absolutely. That is what I bought them for. These guns are strictly range guns. They sit about between range sessions collecting dust. When in the range bag they bang about with other equipment and the lenses are vulnerable to dirt, dust, and whatever else could happen under these circumstances. I don't have to worry about them with these caps on. That is all I wanted to accomplish. Putting these on and taking them off requires a little work and concentration. Nothing I even consider when unpacking for or packing up from a day at the range. If they were to be used on a hunting gun, I would have no problem using the before and after the hunt when equipment is being readied or retired for the day, but would never consider them for use during a hunt. Getting them on and off is just too impractical under those circumstances. So, to summarize, they do exactly what I would want them to do for the situations that I use them for. I could not be happier. Yes, they take a little tugging. But, I am not yet so old or weak that I can't handle it.

Great cover that I received and of good quality, got this for a Vortex VMX-3T 3X magnifier that fits just right around the front and back. The material feels like a very thick latex rubber and compresses around the glass opening to create a dust and water tight seal. The tension on the bands felt a bit loose so I crossed the bands to make them tighter and hold in place when transporting or storing. This works really well in protecting your glass from scratches or dust.

This is an in expensive cover that is great for field use. Flexible, so it fits in my holster too. It is for a shorter scope, so pistol or scout scopes are okay, but it probably won’t work on a rifle scope.

Works initially, inexpensive...works great initially but don't expect longevity. The rubber degrades over time, you might get a couple of years out of them.

For a one size fits all cover, it's ok. However it is a little big for my vortex sparc. I had to tie the line/ribs that connect the covers to tighten it.

I have a Weaver 2X28 Handgun Scope that is 8.4" long with 32mm lens bells on each end. It is well made and the rubber construction will hold up for a long time. This scope cover fits my scope...but just barely. The cups fit the bell housings of the lenses just fine, though because of the length of stretch, it's a bit of an effort to get on without smudging the lens. Once the scope cover is on, it is a little difficult to remove, as it is I'm very close to stretching it past it's limit. I'm even a little worried I might snap the bands taking it on and off. This cover would be fine for anything smaller, but I'm doubtful it will fit anything larger. It would have been nice to have a scope guide or size chart to assist buyers with this online purchase.

These are great, I have 5 of them, 1 Tini and 4 Regular size, that I use on scopes ranging from a 4X fixed to a 4.5 to 14 X variable. They are inexpensive, seal out dirt and dust, are essentially indestructible, and you can quietly pop them off in a second if you are hunting. At the shooting range I store them in a zip-lock bag to keep them clean. If they do get dirty, a little water and dishwashing soap will take care of it....make sure they are absolutely dry before reinstalling!!

Perfect.

Easy and simple and provides good protection. I could not find caps to fit a red dot scope but these work wll