Waterproof RTD PT100 Temperature Sensor - Jaybva Stainless Steel 3 Wire Thermistor Probe for PID Temperature Controller NPT 1/4" Inch Pipe Thread with Insulation Lead Shield Wire -50~500℃ with 2m Wire

I can't complain when a sensor just works and this it does. I have my K type probe connected to an InkBird PID controller, replacing the stock one it came with. This thermocouple screwed right inside the existing 1/4" screw terminal in my pot and sealed up nicely when tightened. The temps read pretty darn accurately and the stainless finish on the thermocouple appears to be up to par. The braided cord on this probe is quite long and prone to nasty kinks, so be careful with it.All things considered I will absolutely buy this again if needed!

This will monitor the heat in the powder coat oven.

Simplicity of mounting

This is a nice probe for the price. Couldn't find anything flaws on the case and was easy to add a male plug for ease of change out.Four stars until I see how long it holds up. I'll be using it in a lead melting pot.It was within tenths of a degree when tested against a known probe and worked well up to 600°f without being in liquid lead. Will do that later.I don't think there will be any problems there but it's ability to last when used in and hours long sessions sporadically will be the telling factor.The male/ female plug sets were purchased at the same time for this project.

Worked . But wasn’t sure if this is the one that burnt out quickly

Works as described.

The clerk was great

not sure if there is something wrong with my setup(tested everything and i cant find an issue) or faulty sensors. had 3 go bad in a week. had my last 1 of 3 sitting inside reading air temp for testing, it was stable at around 20c and about 48hrs later it started to fluctuate between 2C and -60C . measured resistance and it went bad. they seemed like high quality sensors, so if it was my fault they are a good choice. but as of now i cant keep buying these. for anyone interested i had these connected to a Click PLC with the RTD module.

Well made product did the job as expected for my outside fish pond.

I have long suspected that something is amiss in this lab and this PT100 probe has enabled me to prove it!116.79, minus 0.56 for the resistance of two leads, minus 100 for 0℃.... divided by 0.385 equals..Forty two! I knew it! This coffee is cold!Seems to work okay out of the box, I've seen some other reviews doubting its longevity but only time will tell that.I particularly like the three lead arrangement, it's quite a clever way to null out the resistance of two - leads by giving you a third lead to use as a secondary current path just for measuring two of the leads.Assuming that all of the leads are pretty much identical, this gives you a pretty good idea of how much you need to subtract from the reading across +/- leads with the sensor in between.

Not accurate at all. Fluctuates temperature all over the map. Do not recommend.

Es tal cual lo ofrecen. Muy buen producto.

good quality part