Rockler Table Saw Crosscut Sled

Out of the package very easy to set up. I tested the 0 stop and it was +-1/256 per foot off. 5 cut 6" Perfectly usable and better that I could do to try and make it better. For those complaining about a right table, just make your own. 1/2 inch plywood and you are done. If you are purchasing this, odds are you have made your own xcut sled in the past. Cons. The Flip miter stop is useless. It cams to the right when you tighten it up and it has a > 1/4" gap at the bottom. Your best bet is to make your own right table with a miter stop. Especially since a left stop is not all that useful and you will be relying on your fence to make accurate cuts.

This crosscut sled is awesome. It works great on my Ridgid R4520 10 inch table saw. The set up is a breeze and they make it very easy to get a .001 inch accuracy in seconds. Can you build a better one to suit your needs and probably be more accurate? Sure I'm guessing you can. But for the price, the accuracy and the ease this is well worth the purchase.

it’s cheaply made at a premium price, not as accurate as they say it is, if you tighten up the bearings in the mitre slots, it’s very hard to push, if you loosen them off then you get sideways slop

I got my sled today 8/26/19 set the sled up maybe took 15 minutes. Calibrated it on my table saw and did some practice cuts. I did a 90 degree 45 degree and even a 22 1/2 degree all were perfect. As i did these cuts I checked them with my digital level and angle finder. All three cuts were right on the money. The variance was very impressive within thousands. I do not think I could have built one with that kind of tolerance. Very impressive product. I will by from Rockler again. If there customer service is as good as there products this is a fantastic company.

This sled is a godsend! I've never had more accurate cuts. The inclusion of the adjustable miter, hold down clamp, and sliding stop is genius and makes every job 100 times easier and faster. It works great on my portable rigid saw, with a few addendums. 1. If the bottom of the hold down is not perfectly seated in the channel underneath, it can and will scratch the table surface. 2. It would've been nice if it came with a right-to-left reading ruler installed on the fence. I had to search for a while for one that was short enough that I wasn't wasting 4 ft, but long enough to span the fence. Not an easy find. This I believe is something Rockler could easily remedy. 3. This is probably the biggest gripe. While the sled works great on its own, the drop-off side is almost a must-have. For the high price, it should be included. The decision to sell it separately, by Rockler, almost smacks of greed. Otherwise, I am extremely happy with it and would still recommend it to hobbyist and pro alike.