Panglong Golf Cart Ball Joint Kit-Club Car DS Tie Rod End Set of 3, Club Car ...

Fit perfectly no need for washers to match the cotter pin hole in the bolt as the depth of the sprocket was a perfect match to fit the pin through.

I recently installed these on my 2000 Club Car DS. Overall was fairly easy to install and they appear to be quality replacements. At 22 years old, it would be hard not to be better! I do like that there are grease fittings so you can keep them greased. I would highly recommend as the price is nice for the quality you get. Just remember when you take off the old ones, you should have a reference point for putting these back on. Usually, I found measuring from the breaker nut to the center of the ball joint. You can also break the nut and then unscrew and match the new one to the old one.

Worked as advertised. Most complaints were the jam nuts did not come new tie rods, I just reused the old ones, problem solved.

Fit was dead on, threaded very nicely, packaged really well also and Look high quality. Would have been nice if they came with new jam nuts. Will update if I have any issues. Used on 97 club car DS.

Fit good. Price was good. Only negative was one had a split rubber boot. Put it on anyway since it was newer than the old one that had a split boot and I already had the front cover off to do the work. Not a big deal really.

labeled left and right for your conveinence and come in bags that are numbered.. Much appreciated

These fit my 92 DS Clubcar perfectly. The best part was not having to double check if it’s 2 left or 2 right thread needed and then triple checking that I ordered the right part numbers. Once we got the old ones off these went on without any issue. If you’re rebuilding your cart, these are a great purchase. I only needed to replace 2 on my cart but the price made me go ahead and do all 3.

Great replacement for my blown out club car ball joint. A must do when installing a new lift. Worked perfectly. Spend the extra few bucks and install new ball joints.