Ultrasonic Cleaner Solution - Makes 8 Gallons Concentrated Ultrasonic Carburetor Cleaner - 128 oz Cleaning Solution for Automotive Parts - Safe for All Metals - Removes Grease & Dirt

worked very very well, amazing!!

Excellent clean. Works very well.

I use this in my ultra sonic cleaner, heated most times to about 85*. This solution works well on aluminum and also on chrome tools. After cleaning I drain it into a gallon jug and save for my next cleaning episode. I dilute my mixture about 1/3 solution to 2/3 water in the cleaner, but still experimenting with other solutions for money savings.

I have only used Tillbrook Ultrasonic Cleaner once on a motorcycle carburetor. The carburetor was very dirty and I precleaned some of the circuits with carburetor cleaner before putting the parts in the ultrasonic cleaner. The results were very good. The brass jets, emulsion tube etc were not shiny but all of the deposits and dirt and were gone and the aluminum parts looked almost new. The motorcycle ran good as new after reassembly. I have used the Chem-Dip carb cleaner in the past and the results with this ultrasonic cleaning solution were at least as good if not better.

Works good.

HarborFreight 6 liter ultrasonic cleaner. Right out of the box I needed to clean the head and valve guide for a 5hp duel cylinder air compressor I have had for 30 years. I mixed the solution up as instructed 2 cups of product with 1 gallon of water. Set the heat on 170 degree F and watched the magic after 15 minutes. Of course gasket scraping was another issue however, the results speak for themselves. Product has virtually no odor. Does not feel corrosive. Feels like a mild dish soap. After the head was cleaned I plunked in a 53 year old GM A-body door latch that been sitting for a really long time, at least 30 years in my sheed. 15 minutes later you can see the difference. Yes this product works, yes I will purchase again. Stay Safe.

I have used this twice and really worked goid

I used this along with some DAWN dish soap to clean some small engine carbs. I used half of what was suggested per gallon of water. I used about 1 tablespoon of DAWN. It cleaned them to spotless condition. I have the large unit from Harbor Freight. It is the parts cleaner and not the jewelry cleaner US cleaner. Worked great. I didn't have to use any picks or tooth brushes to finish. Clean out of the unit.