TRQ Driver and Passenger Side Headlight Assembly Set for 2009-2014 Nissan Maxima Halogen Only

Took ten years off the van’s age! Fits perfectly ‘cept the bulb holes seemed a little off, but the upgrade bulbs I had went in with a little work. Well packaged and good quality…especially for the price! You need to plan for dropping the bumper - not hard. Maybe eight 10mm bolts along the front bottom and two 8mm in the fender well. The rest are plastic center pop rivets. OBTW - from Taiwan (yea democracy!)

I bought these for my 2012 Subaru Forrester. The installation was pretty straightforward, even though I had to take some pretty large parts of the front of the car apart during the process. Fortunately, I also purchased some extra plastic fasteners because several of the ones that were original to the car were broken during the removal process. I would recommend you plan on the same situation. The headlights did not come adjusted but I had read another review that gave me a heads up on this fact. Before I took out the old lights, I parked the car facing my garage door and marked where the old lights shined on low beams with masking tape. This allowed me to adjust the new headlights once they were installed. The low beams have a nice cut off point and don’t blind oncoming traffic. I was surprised at how bright the high beams are. High beams project well down the road and illuminate the mountain roads in my area very well. I am very pleased with the lights and hoping that they will give many years of service.

They fit my 2008 Nissan Armada perfectly, they look amazing and are of very good quality

I think it's important to know when ordering this that you won't receive any installation instructions. I was OK with because there are numerous how-to's on YouTube. I was able to successfully install both right and left headlight assemblies. This did involve removing the front fender and grill as well as other flashing and wheel well rims. The headlight casings are straight forward and held in place by screws on the metal car frame. There is no place to adjust angles. After install the headlights are awful. There is a straight line of darkness cut about 30' in front of the car while driving and you cannot see anything further afield. If you were to stand in front of the vehicle this line hits you right at the waist. Imagine that level while driving on a highway or down any road at night. You cannot see anything. The highbeams work just fine. But it is clear to me that the aftermarket manufacturer did a terrible job at designing the main headlight function. I cannot safely drive at night and have to find another solution after spending 5+ hours and $500.

My factory headlights were getting pretty wore out and despite several tries at refurbing them through the years they finally got to where sanding, polishing, and sealing was no longer working right. So with the prospect of needing to replace them I started looking at getting a new set. Seeing the OEM GM housing costs and having my eyes water, I went through researching aftermarket options. Most have terrible reviews with condensation, cracking, or fading plastic so it was looking like I was going to have to pay through the nose for a set of OEM lights. Then I remembered on my old Silverado I went TRQ years ago for a set of replacements and they lasted and never gave me any issues. With that in mind I pulled the trigger on this set. Out of the box (which props to the care taken on packing these housings in the boxes), these look just as well constructed as the factory housings. Plastics feel quality and not brittle or cheap and the wires seem like silicone insulated wire making them quite flexible and likely more heat resistant. Fitment follows as well with them lining up perfectly with little fiddling needed to get them to follow the body lines and the plugs going in with no trouble. I did try them with the halogen bulbs they came with and they do work quite well, however I have a quality set of LED high and low bulbs so I dropped those in as shown in the pictures. Overall these are great housings and for the price an absolute steal of a deal. Given the issues with the other aftermarket housings (and that most don't include bulbs or wiring anyway) don't even bother with them and get these. Now mind I've had these less than a day at the moment and my review is just based on initial reactions, but I'll report back in a year if I have any issues or items of note.

The headlights will not adjust. The adjusting screws turn but do not move the head lights.

Então, comprei os dos faróis, um deles está recuperado grotescamente e com o globo interno solto conforme fotos e vídeo, estou insatisfeito com o produto, queria ver uma solução