335x300x0.5mm Fiberglass G10 Composite Laminate Sheet Panel 13x11.8 (Yellow)

Super hard material. Very well packed as well

I bought this to use as a bed for my 3d printer, and it works great. I have a SovolSV04, so there is a bit of the bed that is uncovered and not usable, but overall this fits well. Make sure you clean the plate before and after instalation to get any skin oils off, just use rubbing alcohol to wipe it down. This does work with most filamaents I used, but I did have to bump my PLA to 70-75 which is higher than what I use on PEI. Other than that, it's pretty much perfect as is. This creates smooth prints, but I did see online if there are adherance issues to sand it with 1200 grit sandpaper. I haven't had to do that so far.

As received the products thickness was greater than spec'd and will not work with my project.

I scored both sides of the sheet and snapped off the excess to make it the right size for my ender 3 V2 and it works great printing pla. After the bed cools you just pick the parts up!

Haven't used it yet, but seem to be good quality.

size and thickness is accurate. Worked well for my project.

Got it in less than a day, exactly as described, perfect quality, a touch pricy but not considering the service

Fiberglass dust every where