HitLights 12 Pack LED Connector 2 Pin 8mm Solderless LED Tape Lights Connector Transparent LED Strip Lights Connectors with Screwdriver Strip to Wire for 12V 24V Single Color LED Light Strips

These worked fine for me. I happened to already own a set of small screwdrivers so I used one of those. I agree with other reviews that say the included screwdriver might be tough to use. I'm writing this review to give you one hint.... Pushing the 8mm COB light strip into the connector is difficult, as the light strip is sort of spongy and it wants to pop back out. What I found worked REALLY well was to find a nice, square edge that I could push the connector up against and shove the COB light strip into it while I tighten the screws. This allowed me to hold it firmly in place until the screws were tightened. In my case, I was putting the light strips above and below kitchen cabinets, so I used a carving board shoved up against the tile backsplash on my kitchen counter. See photo below.

These connectors are great. Used 16 in my kitchen LED strip solution and haven’t experienced any issues. Comes with a screw driver to fit the terminal posts. The led strips still push in after removing the backing tape which is nice and when fully tightened the terminals hold solid. I recommend using a larger electronics screw driver to get these properly tightened. I stuck the tiny screw driver through my finger when it slipped off, so I also recommend tightening against a solid surface rather than in your hand. Great product - ordered again.

Do not buy. It is cheap junk that doesn't work out of the box. Zero stars if I could. The screws doesn't tighten enough to hold the wires or the led strip light.

no complaints so far

Works fine. I wish the screws were just a bit larger to have more holding power. But otherwise these connectors are very effective and fairly easy to use.

just as described. The very small screwdriver is a plus as most are to large for the small set screws.

I bought these to connect LED under-cabibnet lights. They are very small, and I found it difficult to get a good connection tot he tape and the wires. This is done by means of four very tiny screws which fall out easily and can be very hard, if not impossible, to find. The wires don't stay in and the LED strip doesn't connect well. I really wish there were better connectors out there, and I'm looking. I would also add they are just a bit too big to allow the diffuser cover on my lights to fit without cutting away part of the flange on the cover. A minor inconvenience, but it could be better designed in that regard. So, it may work OK for most, but I'm sick of fooling with them and will have to find something else.

These were so easy to use on my led light strips that I have along with my wall!