Tungsten Carbide Blade Set - for X-Models ONLY- NOT for T-200 Model

These blades are the ones to get if you are cutting plywood. I usually cut 3/4" material and thicker and these blades have no problem performing the task. They leave a smooth clean finish.

I purchased these as a replacement for blades for Hole Pro X-305 Professional Twin Blade Hole Saw Kit: Infinitely adjustable to cut all size holes between 1-7/8" to 12": Cuts Plywood Sheetrock Plaster Fiberglass OSB Plastic MDF Hardie Board - comes with both Tungsten Carbide and HSS blades . I was worried that I would burn through the tungstun carbide blades the kit came with cutting 12 holes through 1" thick plaster. Turns out I was wrong to worry. I was able to use the original blades that are the exact same as these and they show no sign of wear so I actually did not use these but I can only surmise these would be of the same excellent quality. I ended up keeping these so I can use them when the time comes to switch out the blades.

I used the set that came with the saw and worked great but we hit some plaster that must have been made of concrete it wore down the cutting edge quick wouldn't even make a round mark I ordered more of these before I put them in, one of my workers said he could fix the old ones I told him to try he came in the next morning the cutting edge he put on them was nothing like these, he said give them a try now. They cut better then they ever did we have cut so far twenty five holes each hole had one inch of plaster they cut in less than ten seconds they need my man at the plant to make the cutting edge that will never happen still have the new ones I ordered.

These blades are great! They made short work, less than one minute for each 5 inch recessed can lights hole in a plaster ceiling. No cracks no errors a perfect fit. I would highly recommend these blades along with the hole pro-cutting system. I am a licensed electrical contractor and wish I would have purchased this tool sooner, would've saved me a lot of time and energy.

Only had to use this one time so far. Cutting through 3 layers of plaster for 7, 9-1/4" holes overhead for heat vents. Worked flawlessly.

This made doing holes in plaster super easy, plus I drilled 10 holes and was good to go.

Used it for a ceiling tile project, and it worked flawlessly for over 300 holes. Still sharp after all of those cuts.

I get more than 120 holes in drywall and nearly as many holes in Hardi cement board with these blades. With plaster it is more like 30-35 holes but that is still very good. No way to tell from looking at a tungsten carbide blade how good the carbide is but the results speak for themselves with these Hole Pro blades. They last much much longer than any other carbide hole cutter that I have used.