Mould Stain Remover Gel Cleaner - ACTIVE Heavy Duty Stain Cleaner for Front Loader Washing Machine Seal, Rubber Gasket, Bathroom Grout, Shower, Caulk - Front Load Washer Cleaning Solution - 7 Fl Oz

This product did an excellent job on staining caused by mould on our rubber washing machine seal. I didn't think it would work as the black marks seemed permanent but I was delighted with the result after leaving the gel in place for a few hours as instructed. Also the gel was really easy to apply. Five star stuff!

I purchased this to clean the door seal of a washing machine we inherited with a house purchase. The door seal had seen better days and was quite discoloured. I was hoping this would kill the visible mould lining the seal and return it to its intended grey colour. Applying the gel was straight forward - though it’s worth noting you do need a Stanley knife (or similar) to cut the nozzle of the bottle. There was no overpowering smell and It was incredibly thick which was great for ensuring it stuck to the surface I was applying it to, but it did mean I ended up using more than I probably needed to had it spread a little more. That said, there’s plenty for two applications in one bottle since it’s a good size. I left the gel to work for three hours. It worked well, removing the black mould and only leaving a slight discolouration in its place. I imagine it would be completely cleared after a second application (or perhaps if I’d allowed it to work a little longer). Clean up was relatively straight forward, but you will need plenty of damp and cloths to get it removed fully. Overall, I’d say it’s good value for money.

Amazing, worked within 2 hours of putting it on! but it did run down with gravity so missed some, any tips on how to make it stick even veritcally would be much appreciated 😊

Great stuff and it worked. Yes it does smell but then bleach smells so not issues there. My shower sealant inot longer has spots of black mould

I was sceptical after trying every cleaning product I could think of, but this did the job. I followed the instructions and left it to do its work for 5 hours. Cleaned it off, which can be a bit messy, I admit, and was genuinely amazed at how clean the seal was. I'd missed a couple of small spots, so I repeated it on those, and you can't tell it ever looked mouldy. I had been worried because it is a Siemens washing machine, and I imagined the cost of a new seal would have been horrendous, so this has given me peace of mind. Highly recommended. Just don't be impatient and leave it as long as possible before cleaning off. It does smell of bleach though, so definitely wear gloves. Worth every penny.

Pretty good. Removed most of the mould stains. A second run over with a new pack could possibly eliminate the mould totally. Would recommend.

It got some of the mould off my washing machines seal but not all of it

In a previous washing machine we used fabric conditioner and it went mouldy quickly. Our current machine that came with the house is over 5 years old and in good condition. For months no problem until... I couldn't get my usual powder sanitiser so I used a well known liquid sanitiser (BIG MISTAKE!!!!) within a few months the machine started to get mould on the door seal. I watched videos that suggested white vinegar, mould removal spray which did get some off and then saw a video that recommended this. I left in on for 5 hours which was enough (instructions say 3-5 hours) and wiped off with a damp microfibre cloth. No scrubbing needed. There are a few small spots that I missed, which I will do later. But the parts that were covered by the gel have gone. Helpful tips people have shared... Use powder products only. Wipe the door seal down after each wash. Leave the dispenser draw and door open to let air circulate.

I almost gave up on the mold stains in the shower grouting. The black mold stains wouldn't go away even with constant brushing. Good thing i tried this product. After several applications, the grout looks new again. All you need is patience.

Our shower is large annd deep and mold grows on the left corners where the shower head is because air circulation is bad. We have had a mold problem for years due to several showers being taken in there every day, the mold could never dry out. I tried bleach, hydrogen peroxide, every type of toxic mold cleaner and it never went away. But it was nasty! So I tried this stuff. First of all, I followed directions to a t! I placed a fan in my shower to really really dry it out. I took the shower brush and scrubbed the dry mold. Then I cleaned it. I dried the whole shower with a towel and let the fan dry it out fully. Then I put on gloves, a mask (you’ll need it- it smells like chlorine!) and eye protectant (just in case, the gel doesn’t splash but there were times when I was squeezing out the bottle that it “farted” and I was glad I was wearing eye gear). The bottle comes with a nozzle that allows you to target specific areas. There is a cap on the nozzle you have to take off. You also have to open the bottle- it’s a foil cover you peel back. Then you point the nozzle at the mold and gently squeeze for the gel to come out. The only trick is not to “scrape” the gel with the tip while squeezing it out- otherwise it moves to the side of the grout and hollows out where you actually want it to go. It took some trial and error to master just having the tip hover above the grout line and not actually touch it, but when I got it, it was pretty easy!!! Then I went to town following all the horrid grout lines. And there were a lot. I’m talking subway tile. I did not have enough of the gel to do the whole thing, but holy cow! You can see where I didn’t put it!!!! I would tap the bottle upside down to make the gel move to the nozzle to make squeezing easier. I used the entire bottle. After I put the gel on, I let it sit for almost 5 hours. It was amazing. The mold was gone underneath the gel. I took a damp cloth and wiped it and the gel had the consistency of dried candle wax and just fell to the floor. I gathered it up and put it in a trash bag. Then I cleaned my shower and let it dry fully overnight. After the gel dries it still smells like chlorine, but after throwing it away there was no remaining smell. I am impressed!!! You can see the areas that I put the gel so clearly, it looks like new tile. Some tips: 1. dry the shower fully!!!!! If the mold is wet, it won’t work. 2. Don’t let it come in contact with clothes! I had a blob fall on my sweats and I rinsed it with water but it left a little bleached spot. 3. Wear eye gear and disposable gloves. The bottle will fart. 4. When I picked up the dried gel, I just held it in my hand and slipped off my glove inside out, trapping it in my glove and creating a little pocket for it to be easily put in a trash bag. 5. Even the gel can stain! I dropped a dried gel in my rug and it left a tiny bleach mark. 6. Be generous with the gel. The areas I didn’t put a lot or did thin lines had some mold spots that did not fully erase. 7. Let the gel sit for longer than you think. I had black slimy mold and I left it there for almost 5 hours. It’s gone!!!! 8. Trust me. Buy at least 2 bottles. You wont regret it. All in all I am so happy to find this product and am already buying more to finish the grout lines. 100% effective.

I bought a house and the washer was disgusting full of mold . This product almost cleared it off completaly .I was not able able to leave it in long enough but even after that the rubber seal has clear spots and some lighter spots and I am ok with that . It was heavy duty black mold .I am positive if I do it few more times it will be completaly removed.

I’ll make it brief. I was skeptical, but I decided to give this product a try and I am grateful that I did. I have 2 bathrooms in my apt and they both have black/orange mold growing in the inside of the toilet bowls. I’ve tried bleach and other chemicals to remove it, but nothing worked. The mold has gotten worse and my family and I have been feeling the effects of the mold from the toilet, and with a newborn child, I’ve grown desperate to get rid of this mold and decided to buy this product. I was skeptical because nothing has worked, but today I ordered this product and got the order the same day delivery and instantly opened this product and began to use it. Can honestly say this product does a wonderful job with removing the mold stain and the mold itself. My bathroom toilet still has some mold, in the inside but I am currently letting the product sit on the mold and then will try re cleaning it again. I forgot to mention, I did clean the toilet with this product and it removed the orange mold that I couldn’t remove with any other chemicals! And it removed a lot of the built on mold. There is still some mold left, but as I said, I will let the product sit on it this time, but for the most part most of it is gone! Thank you to this small business for their help! It worked pretty fast, as soon as it was applied I began cleaning it and it removed instantly. There was no smell, I didn’t smell anything, if it was a smell it wasn’t anything noticeable! They gave me a card with the purchase. I have pictures of before and after and I also have pictures of the card that was sent with the product.

Worked and removed the staining on my front load washer. Docked a star because I left it on for the minimum time (3hrs) and it still bleached my gasket a lighter shade where the gel was. Other than that, great product.