Puig 4051C tank protector model Performance in carbon-look finish, modern and adaptable design that protects your motorcycle’s paint from daily wear and tear

Just what I wanted. Had to cut to fit over unusual tank/fairing lines of KTM (which I expected), but was easy to fit and not easy to see. The photos make the imperfections on the blue part look far worse than they appear to the naked eye. Would buy again for sure.

Fitted perfectly to my xj6, I made sure I did clean the tank with cream cleaner and made sure it fully dried before attempting fitting new tank pad, I think the key to fitting these is not to rush and make sure not to touch new pad with fingers, work from the centre out to remove bubbles and leave it to set for 24 hours and make sure it out of direct sunlight and rain. I took my bike out on the hottest day and it didn't lift at all, I would highly recommend this and would definitely buy another

I ordered this pad in clear for my suzuki and found it easy to fit, I actually managed to peel it off and refit it as I messed up the first fitting, The pad has remained sticky enough that it has adhered well to the tank without leaving residue behind. If I had one minor complaint it is that the pad is physically not very wide and offers limited protection, I would like to see a wide one for us er... wider riders.

I moved this 4 or 5 times to line it up and it still stuck no problem.It looks great and the perfect size.The only thing to watch for is I bought the clear one which shows any imperfections in the paint so I’d probably go for the carbon look if I bought another.

Had some scratches from my biker jacket on the tank so bought this so it wouldnt happen again, stuck it on really easily and seems to do the job, looks quite nice actually. The bottom is just a tiny bit wide but not a problem. Sticks on well and hasn't moved. I was worried that it would cheapen the bike - but no looks good.

Heating up the tank and the sticker slightly with hair dryer or heat gun is a must, don't try and do it without as it won't seal properly and will need replacing. Easy to cut to size required (with scissors) hardens well. Looks good

It’s a pad, protects your tank. Tank is in fact protected 👌🏼

I tried to gently apply this and still managed to get rained marks along the edges Removed and fitted a genuine Triumph rubber protector

De momento no tengo queja. Fácil de poner y no se ha despegado ni una sola punta. Contenta. Vale la pena gastarse un poco más e ir a lo seguro.

Plakt perfect

Il prodotto è molto valido, l'adesivo attacca molto bene e la posa è stata semplice. La protezione offerta è molto buona. Importante scaldare col phon sia l'adesivo che il serbatoio, una volta istallato scaldare ancora e ripetere le pressioni su tutto l'adesivo

Is mooi van ontwerp en past perfect en verkleurd niet hangt er al 1,jaar op en is nog als nieuw

Very good. No complaints