AC Infinity CLOUDFORGE T3, Plant Humidifier 4.5L with VPD Humidity Controls, 10-Level Precision Vaporizer, Extendable Targeting Hose and No-Leak Seal for Grow Tents

Great humidifier. Easy to use and compatible with other AC Infinity products. Recomended for 4x4 tents. Shuts off when out of water and starts right back up as soon as you add more

This works quite well connected to the AC Infinity AI+ UIS controller. My only complaint is how often they recommend you clean it, and that is just me being nitpicky about it. It works as advertised and was extremely easy to setup and have running in a short time. The water capacity is beyond what I probably needed, but I bought it with future expansion in mind. It's not difficult to fill, but if you have the 4-way hooked up without it being lifted, it can get in the way a little. Also to note that it makes next to no noise whatsoever.

This review is for the AC Infinity CLOUDFORGE T7 Plant Humidifier for Grow Tents, 15L, VPD Humidity Controls, 10-Level Precision Vaporizer, Extendable Hose, Targeting Pipe, No-Leak Seal I am so excited to write this review. Almost as excited as when a saw this humidifier work for the first time. I have a 10ft x 10ft greenhouse. It is very important that during the winter I keep it at a temp between 65 degrees - 70 degrees F It requires two milkhouse heaters to maintain that temp differential. As the weather gets colder, they run more. As they run, they dry out the greenhouse. My previous humidifier was an evaporation version. It worked really hard to keep up with the heaters. Then I found this humidifier. WOW! This humidifier works much better than five of the other one. In the description its name is CLOUD FORCE. That is exactly what you get. It comes with several different attachments, but the one I use sends the water vapors up about 2ft above the humidifier and then has a 5 hole distributor on top to send the water vapor in 5 different directions. When it is going full blast, it creates a cloud of vapor in my greenhouse where visibility is almost zero. I have the controls set at full blast because I have it plugged into my greenhouse humidistat that monitors the humidity and turns the humidifier on and off as needed. I am so happy the humidifier remembers its settings even when its power is cut off. As I said earlier, my old humidifier had to struggle getting the humidity to an acceptable level. This new one can change the humidity in the greenhouse from 20% to 80% in a matter of minutes. I have a monitor in the room that graphs temp and humidity as well as other parameters. The humidity graph when I turn on the humidifier has a very sharp vertical spike as the humidity raises. Then when it is on auto mode with my humidistat, I get a zigzag pattern as the unit is turned off and on the maintain humidity between 65% and 70%. As long as I can keep it filled with water, the humidifier has no problem maintaining the humidity levels. I am using distilled water to run the device because it cuts down on deposits from the water. This device can pump out 4 gallons of water easily in a day. I was going to go broke buying distilled water, so I bought a distiller to make my own. That is working out great. When the device runs out of water, it turns off the vapor making and just flashes the screen to let you know it needs to be filled. The other day I heard a noise which sounded like it came from the bottom of the humidifier. I could not be sure if it was the humidifier or one of the heaters. It sounded like a bad bearing in a fan motor like older computers make when their fan is going out. I immediately contacted AC Infinity to report a possible problem with the device. They responded the next day with an offer to replace the unit. I told them that I wanted to research whether the problem was with their device or my heater. The problem is that testing each device has not demonstrated the problem again. So, I can't yet tell which one it is. They told me to keep monitoring the problem and if it occurred again and it is the unit, they would replace it. That is exceptional customer service. I said I was excited to write this review because this is truly an amazing device and customer service is great. What more could you ask for. I can will try to post some pictures, but will depend on how well my phone cooperates with the Amazon review feature. I will try to show the humidifier creating its cloud and also the graph of how steady this humidifier functions when it has water. The spikes that go down quickly are where the humidifier runs out of water. I easily give this device and the company 5 stars. UPDATE: I have now used this humidifier heavily for over a year and it is an amazing device. It is doing a great job at keeping my plants very happy in my greenhouse. It puts out about three gallons of water a day on very cold days. That is because on cold days my heaters have to work harder and they dry out the air. The humidifier keeps the humidity up in the 70% range working to combat the drying effect of two space heaters. I had to buy a water distiller to keep up with the demand for distilled water, but by only using distilled water, I am not getting a buildup of calcium in the device and I have not had to clean the filter in the humidifier. This is a very quality product. I could not be more pleased.

This humidifier is worth its weight in gold. I grow Nepenthes pitcher plants that need to constantly be in 80-95% humidity and this completely changed my game. This device is SO much more than just a plain humidifier. It has several different modes you can use. It can be fixed to maintain a specific humidity or VPD and run automatically when needed (it has a probe that detects humidity, VPD, and temp). It can also be set to 1 of 10 intensities, and you can actually set it to an on state and off state of different intensities. Most useful to me has been the cycle mode where you set how many minutes you want it to run and how many minutes you want it off in a cycle (which can be a serious pain to program in traditional timers). If I leave it at just the 1 intensity, the water will last almost a week (in a small environment). Just buy it already. Your plants will love you for it.

EDIT: it's down to 1 star, because i hadn't been using it, then after less than 48 hours of use it wont turn on again. it wasn't even heavily used. there was still a quarter of a tank, (it was set at 50% humidity). this thing is built like garbage. even though it was blowing humidity into a tent and was outside the tent, it still got moisture into the screen area somehow. just stay away from this thing. the vevo sun i got as an alternative, while not as fancy has been running non stop for months without issue. this thing cant go a day or 2 without breaking. Thus should be a 5 star, but mily unit melted its housing within the first 24 hours. A bunch of moisture somehow backed into the housing and shorted the screen, and eventually the unit overheated and melted its housing. Which was scary, cause its really durable plastic. I could have returned it to Amazon, but I gave ac infinity support a try instead.. they were OK, but lack luster, I ultimately didnt send it back to them because they made what I interpreted as vieled threat that they would hold the unit hostage (make me pay to get it back) if they couldn't replicate the problem. I wasnt a fan of that... so while pondering what to do with it, the unit dried out, and to my amazement the display started working again, and the unit works just fine, albeit I have to slip something under the back legs to keep it level. So there's some quality there. Its been working fine since then. As far as functions its great. This was the one AC I product that I got that didnt come with its own documentation. It did come with some but they were for other models, which caused some confusion. Once you figure out how these display panels work though, they all work relatively the same, and its becomes almost intuitive to program/use. I'm sure I would get better results with one of their controllers, but alas I dont have one. Its really quiet, and starts doing its thing quickly. Overall I would recommend buying it, if you have the need for it. Even for non growing purposes. It does need to be refilled a lot though. Should be a five star product, but it should have some sort of sensor that shuts it off if moisture gets in the housing.and whole ACI technically did nothing wrong in their support, the concept of having to pay them to get the item back if they claim its not their fault rubbed me the wrong way. So thats why it gets a 3..

The unit seems nice & well-made, BUT the lack of help/support for this model is dumbfounding. Even on ACI website or YouTube channel, there's talk about the T3 & T5, but practically nothing (useful) for the T7. The booklet that comes with the unit is not bad for a "quick start" but I had questions about basic operation of the unit.. i.e. can I change the flow rate? how can I better understand the "cycle on/off" function? why isn't the unit sensing my probe? None of the answers can be found via ACI sources & the few videos about T7 on YouTube are trash. I did have an annoying problem out of the box.. why wasn't my probe working? (display showed all "---", indicating that it didn't think my probe was connected). I got the answer by searching Amazon reviews of this unit for the word "probe" & then reading all the results. FINALLY, I found one reviewer making a quick comment about making sure the probe was really pressed in to the port. Voila! That fixed it. With ACI having a tiny white seal around the plug (to keep out moisture from the port), it requires a firm push of the plug into the port (so you don't see the white ring). I use 1t of hydrogen peroxide per gallon of water to prevent pink mildew from growing in the bottom of the tank. Humidifier works great... distilled water is a must to prevent mineral build up & white dust from forming around the tent. If you need a little heat in your tent, consider the T5 humidifier instead of the cool water T3 or T7 + separate heater.

This humidifier specifically for plants is so much better than the last Humidifier that was simply a room humidifier. I love how I can get the humidity where the plant can benefit from it most with the tubing and pipe attachments. My plants are not in a greenhouse which traps in humidity I don't use the wifi option. I just adjust the amount of humidity on the panel manually with the up and down arrows soon's I found that feature. The other setting are way to fancy fer my needs so I can't comment on them. Usually I have it set to 3 to 4 during the day and 1 after the grow light turn off. It usually requires water added every day or two but that's no different than what I'm used to. It shut off one time when I accidentally let it run out of water. I was so pleased when it started back up quietly. The last Humidifier would make horrible noise fer quiet a while when it ran out of water and fer quite some time after refilling. It isn't quiet but it's not obnoxious either, just more white noise. Adding water is a bit obnoxious tho. The place to fill is in the back but the control panel is in the front. Would have been a better design to have the fill opening on the front or at least on the side. I can't turn the humidifier around so need a bit of careful pouring to get the water in without spilling. Not a deal breaker but an inconvenience. Can't comment on longevity as it's only been in use fer about a month.

I use these for my 2 snake tanks to regulate humidity, they have been running non stop for almost a year with no problems, I really like that it’s has an auto feature and humidity sensor.