POWERTEC Metal Drop Leaf Table Supports 4PK, Sliding Hardware for Folding Kitchen and Dining Tables, RV Bracket (71426-P2V)

I use these supports for drop leaf sofa/entry tables. They work great and are easy to install. Just a warning - the table has to be AT LEAST 16" wide or these supports will be too long.

They worked wonderfully. I used three of them on an extension leaf on my sewing table to give my quilt somewhere to land when I was quilting they were simple to install and sturdy.

I guess it is a problem with the switch on one of the two lights in the set -- my preference would be to have them be "off" until I turn them "on", but there is also a "motion activated" setting. I have both of mine set to "off" but one of them flicks on by itself anyway. I've fiddled with it plenty but can't figure it out. Not a big deal, but it needs to be charged more often. Otherwise, they are pretty cool -- easy to install the magnetic strip under the kitchen cabinet, easy to use, provide a good amount of light. Handy in case of power outage, too.

These work great. Held the leaf sturdy. I used 2. If not enough room underneath, just install the sleeve without the arm. Then slide in the arm in after the leaf is up. There's a little nub that holds the arm into the sleeve. Just file it down to remove the arm.

Held table leaf flat and tight

Easy to install and operate, these supports are just the ticket for drop leaf tables!

I built a drop leaf dining table and used these. They are working fine some 6 months later.

Sturdy but just too big for what I needed.