T8 Main Brush Motors are Compatible with Ecovacs DEEBOT OZMO T8 AIVI/T8/N8 Pro/N8 Pro plus/N8/N8+/920/950/T5/N7 Robot vacuums

After ruling out everything else, my brush would start/stop and eventually report as a tangle. Tried a new main brush, etc. Eventually I decided to dismantle the whole thing following a YouTube video to check the gears out. Found some crud, cleaned, greased and put it back together. Same problem. Figured it had to be the motor itself, so I purchased this and did it one more time. Presto! Everything works perfectly now. Perfect fit and came with the identical setup as the original motor. Note that if someone is considering doing this, there are LOTS of parts to remove to get to it. Definitely watch that video before attempting this.

fits N8 ecovacs, and works perfect

Have an Ecovac Deebot N8+, this motor fit perfectly. The wiring was exactly the same length and blue, red color wire. I did see where someone in comments said these where used. I opened the gearbox up and did see a little black grease around brush drive gear (gear looked new). All the other gears look new with clean grease. Looked like it was tested to me. Ran the vacuum for about 2 hours so far and motor is still working.

I just replaced this tonight, my old main brush motor failed. After taking it short I can see why, the old gear box lubricant has gotten time off sure and grime in it over 3 years Kind of a pain to remove the main board to screen the old main brush motor to remove, but that is just the design of the vacuum. Perfect for and this plus the new side brush motor means I didn't have to spend hundreds on a new vacuum. Very happy was an exact match to the one I pulled out of my n8 plus

Very good replacement motor and gear.