Dynasty PROAUDIO WSA-5RP-PLUS Wireless Surround Sound Rear Speakers Kit with 2 x 100W Amplifier Built-in (Metal Chassis Design)

I use this for rear surround speakers, and it works exactly as I'd hoped. I have a triband wifi network and was concerned that there might be a conflict... but there's not. I've had the Dynasty for about a month and there's been no pops/clicks/noise in the surround speakers, nor has my wifi slowed. When pairing the Dynasty TX and RX I made sure I was streaming Prime videos on my TV's and computers in the hopes it would find and connect to an "empty" channel. It did, but I really don't know if the high level of wifi traffic helped or if I just got lucky. But the end result is that neither one affects the other. The TX and RX are about 20 feet apart from each other, and the arm of a couch blocks a direct line of sight but I've had no issues with dropouts or pops/noise. The amp itself is quiet too, no hiss at any level. It does have some processing delay... YPAO thinks my speakers are almost 30 feet farther from the measurement mic than they actually are, but my Yamaha A4A compensated and everything is time aligned in the end.

Kinda pricey, but plug and play straight out of the box. No issues with connectivity. Good solid build should last a while. No discernable audio lag. Update: I did have an occasional unexpected click from the speakers. 20' distance with only the couch in between. I upgraded both antennae to 12db gain for WiFi and haven't heard it since. Update2: I had an idea to change my setup and bought a powered center channel speaker intending to use the sub channel to send it with L&R speakers. Turns out the sub channel has very low sampling rate which cuts out everything over about 2kHz.

Installation and set up was easy. Straight forward after getting a magnifying glass to read the instructions. First movie, no artifacts. Second, much popping and cracking. Replacing antennas helped. Fewer but still pops. Moved sending unit away from amplifier helped again. Fewer still, but still. Looking for even better antennas. Yes, in line of sight and only 13’ apart. Quality of sound quite good with no latency. Not 5 stars yet. Looking for a solution. Sony ES amp with Definitive Technology rear speakers. Good stuff helps, I think.

This wireless audio device is exactly what I needed to add a sub woofer and rear speakers to the TV set-up in the den. Now I feel really immersed in the environment and the fidelity is great. The PROAUDIO WSA-5RP-PLUS came with all the connector-types and wires necessary to make the set-up easy. The transmitter and receiver paired immediately upon power-up. It was excellently designed -not overly designed- so there is no app to download. I wish more products would take a hint from the simplicity of this design and stop adding so many complicated and frustrating features.

I forgot to include rear surround sound cabling in my house, so use these to send audio to 2 rear surround sound speakers, combined with my amp which has 6 other wired speakers and a sub. First thing, this replaced another similar product that got fried in a storm - this is superior when it comes to consistency and lack of interference or noise on the speakers. Like the other product, using this method introduces significant latency when mixing wired speakers with this, however using your amp setup (I use Denon Audyssey to auto configure) it will set the delay/latency options appropriately you'll just see they're much higher for the speakers driven by this product. That is due to being wireless and the overhead of wireless transmission - in other words it cannot defy physics! That aside, it works great and would certainly use it again if the situation arises.

They work flawlessly and look good on the TV cabinet, but they are very expensive

First off, I did some research on wireless units and this system seemed to be the best available out there. The amp is robust and well made with banana plugs connections but the transmitter will only accept bare wire or pin connections....I have always used pin connections as bare wire always seemed to drive me nuts. Installation was straight forward enough and for me it was plug and play. Once all hooked up the blue light on the transmitter and amplifier starts to blink blue and then almost immediately, both units are solid blue indicating that you have a solid connection. Just make sure you don't have anything obstructing the line from the transmitter and amp and your good to go. I experienced no issues at all.....just crystal clear music with no distortion. Best part is now I have surround sound with no wires from my receiver. I think you will be most impressed with this system....I certainly was !!!

Well made. We purchased the high power antennas. No drop outs or interference in a house with 50+ Wifi devices. The transmitter is about 16 feet from the receiver, and the signal has to travel through us sitting on our sofa. No problems at all. Set up was simple. Plug & play. Having the rotating volume knob on the front makes it easy to bring up the rear speakers. But if you've carefully balanced the sound with Audyssey, you lose your set up with a swipe of the duster. The rear amp is powerful. & Gives good bass through our KEF table-top speakers. We've used other wireless rear amps that never really worked properly. We're really pleased with the power and solid manufacturing of this system.

I should have listened to everybody’s reviews about the poor connection. I just hooked this thing up and I really really wanted it to work, but it does not work at all. The Wi-Fi hooked up immediately, but I cannot get it to play properly. Constant signal dropouts. I tried to switch channels, but I can’t seem to do that. I really need some help with this thing, because it does not work at all. Constant popping and dropouts. The single is very poor. Both units are less than 11 feet away from each other and there is a full line of sight. I just cannot get it to work. I’ve been pissing around with it now for about four hours, very sad about it because I really want this thing to work. If you are the manufacturer and you are listening could you please reply back with some help there has to be something I can do to fix this issue I do not want to have to send it back. ——update—— I finally figured out what was causing all the issues. This is very important because many of you will have the same problems. Make sure the transmitter is at least a meter away from your router or Wi-Fi device. The minute you get it discard the antennas that come with it. Go on Amazon and buy two aftermarket Wi-Fi antennas and install on device. The device still has pops here and there but very seldom does it happen. I am now happy with the product and will not return it. I am giving the device three stars because it was such a hassle trying to figure out how to get it working properly. Advice to manufacturer put a better Wi-Fi antenna on this device and your reviews will improve Drastically. The class D amplifier in this unit is excellent.