Bathtub Repair Kit - Enamel Tub, Tile and Shower Tray Refinishing Kit for Scratches, Holes, Cracks - Waterproof Sink Repair

Really good strong product. The apron of the paints to mix the perfect colour is great. Also great to touch up smaller cracks. Comes with everything you need.. Gloves. Spatulas, mixing card, protection stickers for around the area. No issues with it

Was impressed with this, was easy to use and filled a chip on my new sink which is hardly noticeable now and handy to have in for other uses

Our relatively new bathroom suite suffered a small chip to the ceramic sink basin. Whilst only a few millimetres wide, once seen, it could never be unseen. So this meant either paying several hundred pounds to have the unit replaced, or attempting to repair the chipped section. I figured that it made sense to attempt a repair first: This product proved to be outstanding, and after using it, the chipped section is now completely invisible, and the basin is as good as when it was new. The key reasons why I like this product are: 1) It has quite a long cure time, needing to be left for 24 hours to set. This enables the two tubes of paste to be mixed really thoroughly. I mixed the stuff for a good few minutes to ensure that it set really hard. 2) It does indeed set nice and hard. 3) Luckily its colour matched our Roper Rhodes basin really well. So well that it is not possible to see where the paste was applied. I found that the following key aspects were necessary to get a really professional result: 1) Ensure that the damaged area is thoroughly clean. I used methylated sprit on a lint free cotton cloth to clean the surrounding area. 2) Work slowly with attention to detail. 3) Apply the product thinly, as it is easier to apply a second layer if needed, than have to remove a lot of excess hardened filler. 4) Crucially, I ditched the supplied abrasive and used my own wet and dry paper, used with water, and working down with several finer grades. 5) I started with 400 grit paper and moved down to 600, 800, 1000, then the really fine 1500 grit paper. 6) The 1000 grit paper should be used when you can feel that the surface of the filler is just a tiny bit proud of the surrounding ceramic surface. 7) When moving down the grades of abrasive, use a fresh sheet of kitchen paper towel and fresh water to rinse/clean the abraded surface. Also dip the new bit of abrasive paper in fresh water (so as not to pick up any coarser particles from the previous grade of paper). 8) For the final polishing, I used T Cut paste, followed by buffing with car wheel polish. All in all I am absolutely delighted with this product. It gets a 10 out of 10 from me and saved me several hundred pounds.

It didn't arrive but I have used this before, great for fixing bath scratches and chips

Disappointed with the product, given the good reviews. Firstly the paint supplied ( white and Black) was difficult to open without spilling. But the bigger problem was drying time, I mixed 50/50 with the tubes A&B and added a little white paint(supplied) as the mixture wasn't white. The mixture has been on 36hours now and still not set, was hoping it would be dry enough to sand in a day! I would not recommend this product for these reasons, I think it will only set if you don't add the coloured Paint that is supplied. I will have to remove and buy a new product.

Absolutely brilliant for both porcelain and enamel. Small containers allow whitening and greying from the basic mix so colour matching is onl a minor problem. There is a video on the website which you can download for step by step instructions. After curing for 12-24 hours this has stuck solid and cannot be chipped.

Done the job

I don't often leave reviews but this is impressive stuff. I'm a bit disappointed as I added too much black and so the sink looks cracked. I mistakenly thought I could address colour with a 2nd application. My advice would be - if it's not a good colour match, dig it out while it's still soft and try again. It still looks a lot better than the original crack and I don't have the hassle of replacing sink, pedestal, tiling and flooring. It sanded to a lovely smooth finish. I applied a first coat and used a stanley blade paint scraper to remove any proud areas once dry. I applied a 2nd coat with a fine brush so I didn't need to sticker everything up again.

Mi ha salvata! Il lavello aveva uno squarcio enorme ed era da sostituire. A distanza di oltre un anno posso dire che, con meno di 17 euro, ho risolto perfettamente.

produit etonnant

Producto muy bueno , se recomienda, fácil de usar y bien explicado.

Tool funktioniert sehr gut , toll das Farbe bei ist , ⚠️ das schwarz ist tiefschwarz -> nur micromal für grau einsetzen , Weiß könnte mehr sein . Gut wäre noch ein Braunton( für Beige) , dann wäre es ein perfektes Produkt für die Ausbesserung in den hauptsächlich verwendeten Farben im Haus.

Durcit bien vite, et devient très solide. Parfait pour les réparations de baignoire et recevoir de douche