4 + 1 Bay DIY NAS Enclosure, 4 x 2.5/3.5 Inch Tray + 1 x 2.5 Inch Internal Bay, MB ITX PSU Flex, Front USB 3.0, 8 cm Chassis Fan, Hot Swap Backplane, Network Attached Storage

It would be even better if it was 10% larger with better wire management.I wouldn't go higher than 6TB HDD, as there's not much airflow.I'd like 8, 10, 12, 16 disk versions as well please.A version with a standard ATX power would be nice too :-)

別にNAS用のケースを欲しかったのではなくMINI-ITX用のPCケースでHDDが4本収納できるコンパクトなケースを探していたところ本商品をたまたま出くわした。値段が少々高いとは思ったものの即決で注文。到着は予定日よりも2日遅くて多少やきもきした。大きさは他社のMINI-ITX用PCケースより一回り小さく狙い通りだった。ただしその分マザーボードやCPUファン、電源の搭載や配線ケーブルの取り回しには一苦労した。何度も改造をしたい方には不向き。

There are a few quirks to this little gem.The SFX power supply needs the small rear support bracket that is included, and it is not easy to install. You need to attach to the power supply first, then the face plate of the power supple (without the screw that goes next to the cord) then attache everything to the case - putting in the last faceplate screw afterward as that screw head interferes with the case if installed first.the included SATA cables are very stiff for the extreme bends they require. length is also a possible issue depending on your board's SATA port locations.There is enough clearance at the top of the case for 2 additional 2.5" sata drives. double sided tape or YOLO will be required.the drive bays accept 3.5" or 2.5" drives. the tray are not Dell or SuperMicro quality, but get the job done. I did have one get stuck, but a little manual persuasion convinced it to comply.the clamshell cover conforms and matches to the chassis reasonable well. There is no hearding cats trying to get all the locking tabs to engage at the same time.temperatures are very manageable - especially for the single fan in the chassis. This fan is not silent, but not overwhelming and removes a decent amount of heat. It does not have great airflow though.The faceplate lock is a joke for security, but holds decent enough for casual deterrent.Overall, the size, layout, and features of this case make it my new go to case for small NAS builds - which I do quite often.

Lots of modding to get everything to fit but in the end it's a very quiet raid10 NAS using an old micro Alienware I had lying around (All fans replaced with Noctuas). There is only 1 cpu fan that actually fits in this case and since I didn't buy that one I decided to bend the frame of the case to get the motherboard in and lucky enough it had no issues closing the case when bent back. There is also no airflow into the case so I had to drill a hole for a 40x10 noctua as well as another hole for the light up Alienware head on the front (see pics).

小さく安いNASケースです。3.5インチ×4、2.5インチ×1入ります。電源がFlexATXなのがネックですがその分小さく作れます。他の方のレビューにもありますが金具を切らないと電源を固定できない場合があります。CPUクーラーもかなり背が低いのが必要になりますのでご注意。