Evolution Power Tools 185BLADEST Steel Cutting Saw Blade, 7-1/4-Inch x 40-Tooth , Blue

Cuts like butter

Worked really well. I used my cheap Ryobi circular saw. I cut about 16 feet of 3/16 plate steel before the blade stopped working.

These are "low" rpm blades. Using them in a standard circular saw "skill saw" they will not last or preform well. I uses these in my 7 1/4 Evolution metal cutting circular saw and they preform and last GREAT cutting all forms of mild steel for general fabrication off 3/16 plate to 1/2 flat bar. since i have owned the saw i have used 3 blades, and i'm confident that the amount of 4 1/2 inch cut off wheels would easily exceed the cost of the 3 blades to do what i have done so far. not to mention how fast,clean,dust, and spark free the cutting is it has saved tons of time cutting, cleaning up after a project is complete. I've not tried other brands of replacement blades as I'm satisfied with these.

I cut 1/4" plated steel with it flawlessly. First cut, super sharp. Second, not as sharp of course but just fine. I realize this blade is not for life. I think maybe a few more cuts before it's over. Blade did what it was suppose to. Clean and burr free cut. It chips, not rips. Amazing for a skillsaw without a torch. Very good product. Make sure to wear protective gear, chips are Hot.

I bought this saw blade as a spare in case I have problem with the original blade i purchased. it is a decent blade. Very sharp, I had no problems cutting through some thick aluminum. I think the quality is great and look forward to finish the project I started.

Used it to cut through metal siding. Was worried that the teeth would be too jagged. Worked great. Only suggestion to any user of these blades is to use shirts that you plan on throwing away because the metal shards are impossible to get out of your clothing. On that? Wear a face shield, goggles, and earplugs. If not for protection from the loud noise at least to keep the shards from flying into your ear hole!

I've tried these blades three times they cut a couple times well and then it's ruined, my Diablo blade lasted I think 3 months of heavy use These evolution blades are absolute crap

I use this blade primarily to cut slots in half inch steel bars to make branding irons. As long as I go slow, the teeth don't break and the blade lasts a long time. Usually when I break teeth is going too fast or cutting rough surfaced steel, rear is a good example. The width of the saw kerf is the primary reason I switched to a cold cut saw but it is so much faster and easier than a hot saw, I tend to use it for everything.

I cut 11/2" dia. steel tube, wall thickness 0.12", (3 mm). I was really surprised; the blade went through the steel as it was cutting a piece of frommage de chevre. No kidding.

Exelente!

really cleanly cuts through the mild steel

No duró casi nada..y eso que hago con cuidado mis cortes. La compre por que es de la misma marca de la sierra.

Garbage. I got through 3 pieces of steel and the blade started to spark and it was garbage. Now all it does is spark and wines and nothing gets cut. Past my window to return. I highly doubt it was made in Japan... I don't think I will buy Evolution again.