BLEKOO Self Centering Doweling Jig Kit, Drill Jig For Straight Holes Biscuit Joiner Set With 6 Drill Guide Bushings, Adjustable Width Drilling Guide Power Tool Accessory Jigs (Blue)

This is a fantastic tool. It makes it alot easier to use dowels. Highly recommend.

An indispensable tool for accurate drilling for dowels and other mounting hardware. The price was below what one would pay at a retail store. Quality is first first class.

Not great but a lot better than expected for the price. They could have done a lot better job centering it, it was not even close to being centered. I had to adjust the calibration nut (the nut under the two allen screws) close to one full turn CCW to center it but it’s within .002” now.

Very nice tool very well made highly recommend

Worked perfectly! Instructions confusing. The markings weren’t correct but we figured out how to make it work. Nice weight and easy to adjust to board size. Looks solid.

I used this jig while building a dog kennel to align the bars, and it worked great. The top and bottom holes lined up perfectly, which was important for this project. I do wish it grabbed a little more wood, but the shorter design actually makes it easier to hold on smaller pieces. It holds securely and aligns very well as is. The tolerances are good, and the hole-size inserts screw in and out smoothly and it does not mar the wood. It feels sturdy, has some weight to it, and is quick to set up. Every hole centers nicely — just what I needed for precise, clean work.

Centered on 3/4” pine nicely using the 3/8 far left quide. Did not try the others. Used it to draw a centerline with 0.5 mech pencil that fit nicely into the 3/8 sleeve - accurate. However, when I marked dowel spacing along the length the jig alignment markings were off by 1/64” and drilling was off considerably more. For accuracy, I used a brad point 3/8 bit to first dimple the location I wanted the dowel, inserted the bit into the jig without drill, slide the jig until the bit registered, tightened the jig then drilled. Will keep it for small projects knowing the time wasting work around for a cheap POS. Inserts go in ok but obiously out of a mold and not machined. Definately a trade off of quality for price.

"poorly machined...All stuck in the middle of the guide" just turn the bit around, drill thru (with drilling fluid), and ya get a perfectly fitting shim! use a cobalt bit if necessary. too tight is much better than too loose.

Krivy šunt

Have not used this yet but…. I bought it to drill straight 1/2” holes in thick slabs for floating shelf brackets. Essential to get the holes drilled in straight. Pretty sure this rig will work. Wish the larger holes (1/2”) had a threaded sleeve also, not just a hole.

It does what it's supposed to.

I bought this one for my senior high students. It’s easy to use. They like it.

Good value