110V AC Stainless Steel

Pump is sturdy and made well! Was a bit rough finding the 1” fittings to adapt to 3/4” pax but I did find them online. I installed myself in my attic. I installed at point of entry of Maine water line coming into attic that way entire house would get a boost. It’s nice that is comes on and turns off on its own. It runs on a second or 2 after water starts flowing. It’s not a drastic increase in pressure, but definitely does increase pressure. In our case it definitely did what we bought it for, to run a rain shower panel in our shower. I would say it’s about a 33% increase in pressure. You can hear it inside the house as it runs in the attic. I may go up there and install a rubber or foam mat to cushion the vibration and noise. It’s not super loud but you can hear it. Still worth the install.

My first impression of the pump was that it was well-made. After installation, however, I was disappointed. At first, it did not work; the red light was always on. I pulled down the inlet pipe and added some water into the pump head, then it worked! I wondered if it really had suction,but actually the air in the pipeline affected that. It leaked like a sieve; almost every junction had a leak. I wondered if the pump was broken, so I messaged the seller. After seeing their support center link, I had to admit that it might have been my mistake. I had only just received the goods, so I didn't think it was the second leakage type. I did not call a plumber, as that is not a small expense. When I connected the pump to the PPR pipe, I thought the thread between the plastic and the metal was very tight so I did not wind the PTFE TAPE around it (very stupid mistake). I found the upper black switch was not tight, it could be rotated easily. But when the switch is screwed tight, the switch screen is turned towards the side of the pump.However, ugly is better than leaking. I wrapped the inlet and the outlet connections up thickly in PTEF TAPE. This proved to be very effective. Now the pump works very well, except for the noise. However, relative to the high water pressure of the household water, the noise doesn't matter.

This is a great booster pump! I've installed two in the last 3 years and both still working great. The fittings are OK but you should use both teflon tape and pipe dope. I tight the fittings much tighter than I normally would just to stop from forming a bead of water on the threads. I've used Grundfos Scala II pumps in the pasted but their expensive and their warranty is not worth the paper its on!! Bottom line is that you can replace 3 of these pumps for the price of one Groundfos pump. I bought the Amazon 3 year warranty for the first one but never had to use it. Great pump for the price. (P.S. The pump is small but delivers good pressure.)

As an owner of the booster pump, my initial experience was nothing short of impressive. The unit's performance was outstanding, providing strong and consistent water pressure throughout my home. However, after a year, just after the warranty expired, I noticed a gradual decline in its pump output, which has left me quite disappointed.In the first few months, the booster pump operated flawlessly, boosting water pressure to satisfactory levels. However, as time went on, I began to observe a noticeable reduction in its efficiency. The water pressure became weaker, causing a noticeable impact on the overall functionality of my water fixtures and appliances.Despite regular maintenance and proper care, the decline in the pump's output persisted. It's frustrating to experience this issue right after the warranty period ended, as it left me with no recourse for a replacement or repair support.I reached out to the manufacturer's customer service, but they insisted that since the warranty had expired, there was little they could do. It's unfortunate that the decline in the pump's performance happened just after the warranty coverage ended, as this issue now falls solely on me to address and bear the financial burden of any necessary repairs or replacements.While the initial performance of the booster pump was commendable, the fact that it lost its pump output so soon after the warranty period is a significant concern. It has left me questioning the long-term reliability of this particular product.In conclusion, I find myself disappointed with the booster pump's performance. Despite its initial effectiveness, the subsequent loss of pump output just after a year of use and right after the warranty expired has left me dissatisfied and apprehensive about considering this brand or model in the future. I hope this review serves as a cautionary note for other potential buyers, urging them to carefully evaluate the long-term reliability and support offered by the manufacturer before making a purchase decision

Threads wouldn’t seal

I’m using to boost pressure on a line. Works great, a little noisy but not terrible. Install is straight forward but have fought leaks consistently which is reason for lower install rating. Not sure the answer but glad mine is mounted outside as the leaks have been an issue. Reading other reviews seems to be a consistent issue.

I used this to pressurize a water system I put together for my shop where there i no water service. I have two 330 gallon water totes and this pump to provide adequate water pressure. The water pump was very well packaged and no damages to it whatsoever during shipping. The only thing I didn't use was the super cheap teflon tape that came with the pump. It went together very well with no leaks at all!!! And now I have water pressure that rivals what I have at home!!! As a matter of fact, other than the little bit of noise it makes you would think this was your typical city water system as it provides plenty of pressure!!! So far I'm very pleased with the water pump!!!

Works great