Armacost Lighting PureVue Dimmable Under Cabinet LED Puck Light, 2700K (Warm-White Light), 2.75 Inch, Brushed Steel Finish - 213411

Had a contractor flake out on me and didn't finish the cabinet microvoltage cabinet lighting. Just wires hanging down. So after a little research trying to figure things out, I took a chance and ordered these. Amazing -connected the wires, mounted them at the top of the glass-front cabinets, and they work great. A great accent to the kitchen.

Pretty fantastic puck lights, I prefer these over the LED strips. Easy to wire, and throw a perfect amount of light. I have bought 8 so far and couldn't be happier. I would highly recommend.

Has lots of light output. Works great good price feel solid. Very functional. I already had the 12 V DC. Driver. Very nice.

I bought 4 of the black 2700k puck lights and opted for a flush install. The way the flush mount works is there are 3 rigid metal clips that screw on the top of the unit to hold the light in place from the top of the cabinet. I cut the holes in my cabinet with a 2 1/8" inch hole saw and found that the metal flush mount clips were just too rigid to bend enough to allow the puck light to slide into the hole and to be installed from the inside of the cabinet. I thought maybe I could get it to go if I really pushed hard, punched it, or if I smacked it firmly with a rubber hammer, but I didn't because I figured the light would break or bend. But luckily I had access to the top of the cabinet so I slid the unit in with no clips at first and then screwed the clips from the top outside of the cabinet. That worked perfectly, nice and snug. If you can't get access to the top side of your cabinet to screw the clips in then I HIGHLY RECCOMEND YOU TEST FIT THE FLUSH MOUNT ON A SCRAP SURFACE BEFORE YOU DRILL YOUR CABINET just incase you can't get it to fit either. It would be a disaster to cut the 2 1/8" hole and then switch to the puck mount install method which would only need a very small hole to be drilled for the wire to slide through. As far as quality, not too bad! The flush mount looks really good in my glass door cabinets. At the lowest dimmer settings one of my units is very noticeably dimmer than the other 3 but then matches brightness once I get up to 20% or higher. Also, I'm powering these on the same power supply with an LED strip under the same cabinets. At the highest power settings the LED strip appears to over power the brightness of these puck lights but does balance better at mid power levels. Perhaps if you were pairing these with LED strips you should go with high intensity LED strips only if you need task lighting but then maybe stick with less intensity LED strips if you just need accent lighting, which is my setup. Looking forward to enjoying these!

Over the years, we've bought/installed many of these pucks for various places around the home (knooks, interior window openings/spaces, under cabinets, etc). In some cases they replace old halogen pucks which we never fully trusted running since they ran so hot. In other cases, we installed them in fresh locations. In either case, if you understand basic low voltage lighting, they are easy to install (in the case of the old halogens, we just cut the old ones out and were able to reuse the bigger gauge lines with a new driver). They work great, they look professional, and they are well worth the cost. And since they are led they run cool. Highly recommend. We also just purchased 6 of the small-puck versions so we'll see if that install goes well too (it likely will).

We used these puck lights to replace our old halogen ones that are under our kitchen cabinets. They fit perfectly in the space that the old puck lights were in. They were easy to use. I like that they are dimmable. The company has great customer service. My husband called them 2 times to ask questions about installation and they were very helpful and patient. They look nice under my cabinets. And best of all they do not use as much electricity as the old halogen ones did.

Product listing didn't say it was low voltage rather than line voltage making it useless for the planned installation

The best diy lights super bright and easy to install very happy with this brand and quality

Solid metal construction and much brighter than expected. I installed with a dimable LED driver and the dimming is very smooth from full bright to a very low level.

Available in 2700K or 3000K, this is a fabulous lamp. super soft periphery and light, nice warm tones, 350 lumens is bright but not intrusive, 120 degree beam spread eliminates the "spot" effect. I am using just one of these in a shower/spa setup 10' x 5', and it is generous. Absolutely lovely light. Intelligent install design, and dimmable, as all lights should be. 10/10

Better than trash HD sells

Well built all metal construction. Very bright. Completely satisfied.

Great product. More brightness. Good quality. Great quality. Better price