DC62-00299A For Samsung Washer Check Valve

Spent less than $10 to have this less than 24 hours after ordered it. Kind of difficult to install without removing the drain assembly, but I got it done in about 15 minutes. Worked like a champ from the first use. Well worth the cost! Fit my Samsung WF42H5200AW/A2 to replace the damaged valve perfectly.

Good quality. I actually needed part #Dc62-00202a but it would have taken 3-5 days, so I tried this one which came overnight. The diameter of the outer ring and the flapper were a little bigger than required, so I had to do a little modification to make it work. Super glue works great on rubber. If you can wait, I would recommend getting the correct part number, although I'm very happy with how this worked out.

total crap doesn't fit - there's a reason the real one cost 100

My Samsung WF431ABW washer displayed the nd (No Drain) error and would not advance to next step in cycle. When cycle was resumed with the small drain port open (in compartment on washer front), the pump would run and the washer would drain and advance through the cycle. After front panel disassembly (see youtube) to access the drain pump area, I discovered that the drain pump check valve flapper separated from the fatigued body hinge and was plugging the gray drain hose. The check valve is located on the drain pump housing where the gray drain hose is attached. Parts repair sites suggested the DC62-00202A part, but I purchased the DC62-00299A after visually inspecting the damaged part and comparing it to online product photos.

Great replacement part. For samsung front load washer. Check valve diaphragm gasket.

The valve is a bit smaller than the original part. The circle flap part is smaller in diameter which means more water can pass through the drain at a much faster speed. That didn't work for me at all because the water was draining so fast that it began to overflood the pipes in the wall and leak. I just ordered this same part from Samsung's part department directly which cost about $51.00. I am hoping this one from Samsung directly will fit better. Yes, this is a great price but it might not do the job you need.

Not the correct part I need, but that’s not a manufacturer fault. O ring part was too wide so I trimmed it, now it’s installed and working

got exactly what I ordered but should have measured first because my washer uses a larger check valve than this.

Fixed drain issue.