ECO LLC 8 Inch 8" High Speed 14mm/s Linear Actuator Motor 1000N DC12V with Mounting Brackets

This was a great addition for my tractor snowblower shoot. Worked well during the summer when I installed it and worked good during the first few winter storms we had. The only issue I had was that the further it got cold out, the worst it got because it would freeze and wouldn't move. I understand that I am using in a creative way, definitely should have bought something more heavy duty. But no complaints about buying it.

I wanted to wait a while before reviewing this because I was concerned about longevity from such a relatively inexpensive linear motor. But "so far, so good" ... and I'll update this review if/when it fails at a later date. (Whoops; see update below.) I'm using it to open a fairly heavy wooden "man gate" in my backyard fence, and it has plenty of power to do so. I teamed it up with a remote fwd/reverse controller ( https://www.amazon.com/dp/B0CSN27T1D ), which worked out perfectly. I'm a little suspicious of its IP54 claim, but we've had tons of rain here and it's holding up well. I may add a simple rain cover for it soon, for additional protection from above. Update: At the 9 week mark, my fence gate had swollen with rain so that it wouldn't close all the way. But the motor was trying its darndest to close it. I found the gate problem some days later, and the motor had burned out. No fault of the motor, but beware that it WILL burn out if you keep power applied for a long period of time without it being able to move to its STOP open or close positions. Update 2: I ordered a replacement, and once it arrived I installed it onto my fence -- and found that its CLOSE position was about 1/8" shorter than the first one. The drilled hole in the rod is in the same position relative to its end. The issue seems to be that the STOP limit switch adjustment is a little different between units. It would be great if there was access to adjust those open and close limit switches, but there is not. So I had to move over my fence bracket that 1/8" to compensate.

Bought 2 previously. One died in less than 3 months due to a stripped gear. Amp draw has been inconsistent between all 3, even spiking amps from binding non-concentric pinions&shafts. Overall they are fine for what i need, but the poor quality combined with slow & noisy operation leave much to be desired. Budget is only reason to buy these.

Installé sur la chute de souffleur sur mon tracteur. Pas le plus rapide mais travaille bien. Je le recommande !!!

Très bon accessoire, sert à ouvrir la porte d'un poulailler et fonctionne à merveille.