Mount-It! Electric Ceiling TV Mount with Remote and App Controller, Motorized Flip Down Pitched Roof Mount Fits 32 to 70 Inch Flat Screen TVs, Black

耐久性はまだわかりませんが、65インチのモニターは付けられました。 少々動きが遅いけど許容範囲です。

It stopped working after a few months. It moves down a bit, beeps and stops. I press the button again and it moves a bit more and eventually stops completely with three beeps and won't move up or down until I reset it (hold middle button). So I can't bring it down fully anymore. This same exact thing happened with the VIVO model too I had before this. VIVO at least gave me a refund, but neither Amazon or MOUNT-IT want to repair or replace this one. What a nuisance after the hassle these are to install each time

A dos horas de instalado ya no funcionó y se trabó, no lo compren, pésima compra

I have used this mount on my covered patio for the pat summer in an enclosure I built into the ceiling. It has worked good most of the time but as the title states it's a bit glitchy. When I first installed it, the enclosure had fresh paint and the stops for the full upright position were sticking to the paint. This is the glitchy part of the mount. It does not like any resistance when going down. I'm assuming this is a safety feature and unfortunately when it stuck to the paint it would fault out and beep. You have to shut down the power for 20 seconds, reset power and hold the ok button for 5 seconds. It then resets and returns to full upright position. Again, unfortunately it was already in full upright position and would pull the belt tighter each time I reset it. After about 5 attempts I realized what was happening. I had to cut an access door into my enclosure to free the belt because I never expected it to lock in the up position. I un-installed the mount to refeed belt into motor and re-installed in the enclosure. In the end I put a piece of duct tape over the stops so they no longer stuck and it worked flawlessly for a couple months. Then another glitch showed up. If it had gone unused for a few days it would go down partially, stop and beep.. You can hold the down button and it will go all the way down. I believe there's probably resistance on the belt. Maybe it sticks together where it rolls up on itself ( thought about applying a lubricant of some sort on belt but haven't tried it yet). Not a deal breaker but definitely an annoyance. One other issue is the fact that the tv hangs face down when retracted to full upright position and tv screens are glued to the units. Over time if your tv is outside in a hot climate like the summers in Arkansas where I live, the glue holding the screen on will soften and the screen will fall off like mine did. Luckily the tv still worked and I was able to use some super sticky aqua tape from Home Depot made for higher temps and tape the screen down around the perimeter. Shouldn't be an issue again. I would say so far it is a good product with small gliches. In the end, after that long winded review I would say that if you have no other option for mounting a tv, I would use this mount.

This is a very strong ram/gear driven unit and much better than the belt driven unit than was purchased previously.