6 Pack Ground Earth Anchors - Easy Hook Anchor with 30 inch Long x 1/8" Cable, Ideal for Securing Shed, Fence, Green House, Swing Set and More.

We used this to anchor a decent sized greenhouse. They have held up very well. It would be ideal to wet the ground before hammering the stakes in. The greenhouse hasn’t budged an inch in all kinds of high wind and fierce stormy weather.

Works well in my soil conditions.

The seller wrote the sizes in the descriptions, but they are really small in my palm. Looks so small that it's doubtful if this anchor hold up 1000 lbs as said, but since I read a report says 3" bullet anchor can hold up to 1700 lbs and minimum 340 lbs, I will try using them to hold down orchard trellis poles. The hole has a flat bottom. Next Monday is the moment of truth. ----- After trying on silty sandy soil, I now believe that it holds the pole down pretty hard against tension by 4 wires. Will have to see if it sustains when irrigation hoses and trees give more stress on the wires though. I had to hammer very hard to drive the anchor into the soil. I also used a 1m 16mm rebar as a driving steel. I ground the rebar end so that it can fit in the hole of the anchor.

I used all 6 of these to anchor a small shed, as required by local code. Driving them into my sand and dirt soil (not clay) was fairly straight forward. The 1/2 inch driving rod is not currently available on Amazon. In its place I decided to use a 4 foot piece of 1/2 inch rebar but found that the surface texture on the rebar made it too thick to fit in the 1/2 well at the top of the anchor. My solution was to spend 20 or so minutes with an angle grinder removing the texture and tapering the tip of the rebar till it fit right. If I had to do it again, I might try some 3/8 inch rebar and see it that was stiff enough to get the job done.

Bought these to set my snare traps and they're great! Very well made and aren't going anywhere once in the ground!

These anchors are excellent for many soil types. I use this to anchor a large temporary 2 car garage. The biggest challenge is finding a strike bar that will not stick in the anchors hole, I used a 3/8" rebar but had to grind the end of the rebar so it would not stick, I also coated the anchor and rebar end with Fluid Film. Hold great.

I honestly don’t know if these anchors are any good or not. That’s why I gave them 3 stars. They look well-made from galvanized steel and stainless steel aircraft cable. They claim they can resist 1000 LBS of force. However, there is nothing that backs that up, as I found when I questioned the manufacturer. They could provide nothing more than a picture of anchor in a tensile test machine. Nothing to show what it was tested to, and more importantly, nothing to test the anchor pulling out of soil. If you need certification like I do in Florida, look somewhere else.

These things are really strong once buried and set. Ive only had them deployed 6 months but I suspect they would last a long time until the steel wire corrodes and fails. Update: moved the fabric shelter after about a year and these were in as good of shape as when I put them in. These things held that shelter in place all winter when a couple of lesser ground anchors pulled out. They're not easy to put in but once they're in they stay put.

Missing parts not advertised correctly Very dissatisfied