MAXBLAST Sandblasting Cabinet Sand Blasting Portable Work Station Heavy Duty Abrasive Bead Grit Sandblaster Sand Blaster 220L

I am normally fairly good at putting ‘flat pack’ stuff together without reading the instructions. In this case the instructions were not much help, as it was not always obvious if Item A went on top of B, or vice-versa. But it all became obvious during assembly, time taken about 4 hours with gaps. Note: you will almost certainly need two people as some of the screws and nuts would need your arms to be 3 feet long to do up. Also, the flex in the panels makes it hard to hold two panels in place while also inserting a screw and putting a nut on the end. Once the unit is assembled it is sturdy, and I would say of good materials/construction. I did have one problem, the screw holes for the blasting media pick-up pipe in the media hopper were absent. I had to work out where the pipe was supposed to screw on, and then drill the holes. It has one design flaw. The blasting media is stored in a hoper under than main cabinet, so that as you blast the media returns into the hopper through a removable mesh frame inside the cabinet on the bottom to be sucked back up out of the hopper for re-use through a plastics tube that passes through the mesh frame. As a result the (in theory easily removable) frame is not easy to remove, as it has a pipe pass thought it hose clipped to the gun at one end and the pick-up pipe at the other end. I will soon disconnect the pick-up pipe, remove the frame, cut a small gap in the back of it and weld a 25mm Exhaust clamp on, giving a cut-out for the pipe to pass through, so that in future the mesh frame simple lifts out. So.. . . Is it any good? I have access to a large compressor, so I dialled the pressure control valve down to just under 100Psi, the recommend max, and gave it a go. I have never sand-blasted before, so,I do not have anything to compare to, but I am more than happy with the results. A friend cleaned the paint off a maintain bike rear frame in under 30 minutes, it took him 5 days to get the paint off by hand with sandpaper, and even then some of the tighter corners could not be cleaned. I cleaned up a slightly rusty motorcycle bottom yolk in about 20 minutes. A job that would have been impossible with sand-paper given the shape of the casting. I have wanted access to a blasting cabinet for years, and now wish I had bought one years ago. Edit: After a few uses I bough a cheap vacuum cleaner. Without it the cabinet quickly fills with a fine mist of dust making it impossible to see what you are doing while at the same time venting large amounts of the same fine dust everywhere. I plumbed the vacuum into hole on the left side, and removed the blanking panel from the rear. Now it’s 5 seconds of use, it gets a bit foggy, wait 1 second and the fog gets sucked out. You might want to buy a pressure regulator, that way you can have the compressor running from 100Psi to 140, and the regulator set to 90, ensuring that the pressure at the cabinet remains constant. I got one from Amazon. https://smile.amazon.co.uk/gp/product/B01LXI1G7T/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1 Also, one might think the bigger the hole in the nozzle in the gun, the more effective it is. ( The cabinet comes with a selection. ) It’s the reverse. The smaller the orifice, the faster the media comes out and so,the more aggressive the blasting.. obvious in retrospect.

puntuali e corretti

Coole und schnelle Lieferung. Produktbeschreibung ist okay. Könnte man etwas ausführlicher beschreiben.

Très bon matériel ok

Producto según descripción. Buena comunicación con el vendedor. Recomendable