Cerrxian 16cm IEC 320 90 Degree C13 3 Pin Female to C14 3 Pin Male PDU Power Supply Extension Cord for Computer LED HDTV Monitor and Scanner

First I feel I need to indicate how difficult it seemed to find one of these plugs in just the right orientation, AWG, etc. for my need. However, this item fits the bill! My Behringer XR18 and XR16 mixer units mount into my portable gig rack and have an IEC port on the SIDE of the unit. It comes with an IEC power cable that runs straight out! This causes much unnecessary strain on the power cable. That's why I searched out this cable adapter! Now, my mixer IEC cable exits comfortably toward the back of the mixer and into the rack, where my power conditioner receptacles are. The adapter seems quite sturdy and not flimsy in any way. I will have to update this review at a later time to speak on the durability and reliability of this cable, but having checked the gauge and other specs, it seems it will be sufficient for my need. I think this would work for the X Air XR12 model as well, as it has pretty much the same enclosure. I don't know why Behringer didn't ship the X-Air series with a right-angle cable or adapter, it seems it will benefit the system greatly!

I have a Siglent 1202 digital oscilloscope, and for some reason the IEC power socket (C13) is on the side. Recessed from the edge, yes, but any normal cable still sticks out keeping you from putting other things flush to the left edge. This 90-degree adapter was just the trick to point the power input to the rear, while then allowing any standard C14 power cord to be used. Maybe my scope came with a 90-degree cable in the box? I can't remember, and if it did I've lost it. This was just the ticket for my needs.

Necessary if Hanging a tv as the other cords will not be Flush with a flat wall mount.

Used this to turn the cable on my 3D printer 90 degrees so it didn't stick out into the room. Worked great, every bit as good as the original cable, never gets warm, all connections are solid.

Now it's easy to unplug my dual monitor that hangs on the wall without having to take it off the wall.

Two thumbs up!

I use this to extend the port on the back of my monitor. I can then easily disconnect the power cable when I need to move the monitor.

Works well with our projector