Replacement Electrical Plug 2 Prong Lamp Replacement Plugs for Lamps Light Duty, Residential Polarized 10 A 110-250V 2 Wire Straight Blade Can Be Rotated 180 Degrees(6 Pieces)

THESE ARE GREAT REPLACEMENT PLUGS. VERY EASY TO INSTALL ON THE CORD. FLIP UP OR DOWN TO BE OUT OF THE WAY

good deal, done right... thanks !

So a bit weird and clunky, but when you need an inexpensive swivel plug, this was easy to use, and works very well.

I was very pleasantly surprised with how well these were designed. Most replacement lamp plugs do not insure a great contact and either have a bite down connector or a screw that you wrap the wire around that often is difficult to insure a good connection. These are much better designed. Like most repair things these days, instructions seem to be an afterthought. To help out, I am writing mine. I have included a photo of the separated halves and plug assembly. From left to right in the photo is one half, the nut and bolt, the other half, and finally the plug assembly. The installation is a little more complicated but insures a much better and permanent connection. First, you simply cut off the old plug, separate the two lamp wires about 3/4". Strip away about 1/4" of insulation exposing bare wire. Separate the two halves of the replacement plug and be careful not to lose the nut and bolt. Next loosen the screws to each wire clamp but do not remove them entirely. Insert the bare wire into the circular tube of the wire clamp until it is fully inserted past the anchoring screw. Tighten the screw firmly to insure a good contact. You can check the connection by pulling on the wire. It should not pull loos Repeat for the other wire. Now both wires are solidly attached to the new plug. Now remove one of the screws for the wire clamp and loosen the other slightly. You will be able to lay both of the separated wires into the clamp by lifting one end of the clamp and sliding the wires under the clamp. Replace the clamp screws and tighten well. Now place the plug assembly in-between the two halves and connect them with their nut and bolt. When you finish, you should NEVER have a plug failure again. The nice rotation feature also takes the strain off of the lamp cord. This is one replacement plug that will not need to be replaced! It will be my go to replacement plug as long as I can get these.

thank you for these replacement plug extensions for the end of the cables of the power or clocks or whatever you going to call them they work out real good like the adjustments are on them

NOT POLARIZED, but ok

These save a huge amount of space. Lets you push furniture much closer to the wall.

Well manufactured, easy to install. No instructions included but self-evident if you have any electrical experience. Swivel feature gives flexibility.