ICM Controls ICM102 DOM Timer, 10 Minutes Adjustable,Multicolor

Works great. Timer is very accurate. Provides Delay on Make so know what you’re trying to accomplish before choosing this function timer. As stated, it’s not a Delay on Break. Good value.

Funciona

Worked fine but I needed to set timing down to a few seconds and it doesn't have good resolution. Should work fine for longer delays.

I have used these kind of devices to protect my outside AC unit in the past. The ICM102 DOM Timer does what it is designed to do. It comes with a schematic, so you know how to wire the device in your Control system. You separate the yellow wire, wire nuted to the thermostat wire coming to the AC unit and place a stacon connector on the wire you separated from the thermostate wire. You simply get a spare wire, put a stacon connector to one end of the wire and wire nut the other end of the spare wire back on the thermostat wire. Plug the wires into the device where indicated on the supplied schematic, set the timer to the minute you want the AC unit to wait after a brownout occurs and you are protected from brownouts.

Did work fine on 120v ac

This is perhaps the easiest way to stagger start systems that use slave relays. It's hard to set a precise time delay but fine to get past the inrush current of one motor before starting another.

I'm using it to delay my spa pump while the valve actuators turn to the correct postion. I just ran it in series on the coil hot wire to the pump relay.

This product is what it says it is. Works well. When power is applied this relay will allow the load to run after the timer runs out. The time is adjusted by rotating a dial. When power is turn off the load goes off immediately. Sequence repeats.

Easy to replace and to configure .very accurate and repeatable .I set a 4 ton unit to 6 minutes .No more rapid cycling issues

ليس ذو كفائة عالية

Does not time after 5 months and vender will not refund or replace