12w Ceiling Fan Light Retrofit Kit, Led Ceiling Light Fixtures Circle Annular Round Replacement Board Bulb Warmwhite 3000-3500k 1-Pack (Warmwhite 3000-3500k)

I put them up in a very large room that we had fluorescent lights throughout and immediately brought the amount of electricity used down considerably. They are very bright and were super easy to install. I am very happy with them and the ease of use

It works but I wish the lead wires were 12" or 18" long. That would have made the installation so much simpler. Tip: I placed the led driver on the back side of the plate.

Had to custom fit it to my fixtures, but was able to install LED for much less than the circular bulb cost to replace.

Overall 5 stars excellent light, works great as expected. Easy to install.

This took some work to get it to fit. I had to remove the old bulb fittings, but I expected to do that. It is a little dimmer but probably close to the lumens advertised.

1 out of 3 defective, switched out lights, but seems like LED Driver defective. Light just kept flashing. Other two worked great, good light.

It was not made for my kitchen light application but I was able to adapt it. Works great.

Per the instructions you could wire it however you wanted. It had a blue and red wire. What it was going to had black and white. Went black and blue, red and white. Hooked it up, it started flickering, and then it died. Took it back apart and the LED control box thing smelled burnt. Says it’s 12W. Fan said it was 14W max so that shouldn’t have been the issue. LED control box is also quite large in comparison to the light, so if you decide to give this a chance keep that in mind. My suggestion is buyer beware.

Previous fluorescent bulb was not bright. Upgrading to led panel greatly brightens area underneath and uses less power.

Uliliser pour remplacer une lampe sur pied halogene, super :)

Easily installed. Light does the trick in a regular sized room. Definitely a fan and great price.

Exactly what I needed. Works well.

The lamp is very easy to install, with a spring loaded wire connector. It's a pretty slick connector but I tend to be a bit distrustful of such things. I would prefer a more secure connector. It gives off lits of light and a really nice colour temperature, not yellow but not so white that it glares. My only real beef is with mounting magnets. The metal base on my fixture is painted steel and these magnets really don't grab at all. I tested the material with some other magnets that I have and they worked fine so it is not a problem with the material of the base. I wound up gluing the feet in place.