P2 2(1)-IN-1(2)-OUT Amp Amplifier Speaker Switcher Selector Switch Splitter 2-way loudspeaker control combiner box

The Solupeak is a Solid unit. Added a 70’s era Sansui receiver to my Home Theater setup. Using this unit to switch the audio feed from the 2ch Sansui receiver/turntable setup and the Marantz AVR surround system. Sharing Front soundstage speakers in this configuration. Works like a charm - EZ setup - highly recommend

Well made switching unit. Using it to toggle between 2 amplifiers and one set of speakers. Easy setup - banana plugs a bit tight but easy to remedy with a modest squeeze to slightly compress the plug contacts. Will also work with plain speaker wire. The unit is silent with no loss of volume. The toggle switch is firm with a clear click when set, feels solid. Using for 2 weeks, will update if any issues. Very pleased.

Solid, quality piece. Does the job very well

I have an AV receiver and also a 2-channel integrated amp that I play vinyl through. I didn't want to set up yet another pair of speakers and, instead, wanted to take advantage of the Klipsch RP-600M's I recently picked up. After looking around I found this speaker switch and it works perfectly. I plug the AV receiver fronts into A, and the integrated amp into B, and that's it. Just flip the switch and I can go from surround to 2-channel. No loss of sound quality at all. The unit is solid, and the switch is pretty satisfying when you move between A and B. The only knock I have with it is the cables you connect in the back cause it to tip backwards, so you'll want to put something heavy on it to keep it from falling off wherever you put it. All in all I am very happy with this. It's a little on the spendy side for what you get, but it works.

This is a simple switch box for pairing two amplifiers with one pair of speakers, or two pairs of speakers with one amp. It’s probably a little overpriced, but well made with quality parts. I use It to connect two preamp/amp combinations with my speakers, and it works well, with no audible degradation in sound or volume. My only gripe is that with high quality speaker cable plugged into the unit, the cables are heavy enough to tilt the unit and pull the front up off its feet, when sitting on a shelf or table. The front end could use to be more heavily weighted.

Resolved my problem using two amps with one pair of speakers. It was easy to set up, I installed Banana Plugs on the speaker wires coming from my amps to the switch and my speaker wires already had banana plug ends. This switch will also bare wire ends. I notice no degradation of sound as the switch is a passive device. One word of caution though, if you are using a tube amplifier(s) be SURE to set the switch to select the amp you will be using before you power the amp up as not having a speaker load present can cause serious damage to tube amplifiers.

Works as advertised. Simple design.

I received this a few weeks ago. I just finished fabricating the required cables (which I burned in over a 72 hour period) and hooking it through my system. Specifically wanted an A/B switch to facilitate comparing two amps (one tube integrated amp and one SS AVR amp and four speakers. So far so good. Very pleased with switch build quality as it’s quite robust with HD duty toggle switches. It does not introduce any unwanted hum or buzz. Music comes through as clean as your system produced prior to inserting this switch into the pathways. I do recommend turning volume down whenever switching components. Highly recommend.