DC 12V-36V 15A 500W Brushless Motor Controller, DC Motor Speed Controller, Hall BLDC Control Board, Brushless Motor Regulator, Durable and Stable Performance

Just like the other reviewer said, the mosfets are soldered upside down. I resoldered them the correct way, and it still doesn't work, the mcu chip just gets hot. Amazon should be ashamed they let this vendor sell a discarded defective pile of Junk they probably bought for 50 cents from the manufacturer in china and now sell it here like it works for $15. For $22 you can get a working unit with wires and heat sink and case.

This unit doesn't work. Chip get very hot and motor doesn't turn.

The product showed up as expected. It didn’t have any instructions or links to videos. I hooked it up. The motor spun. I attached a heat sink to prevent over heating. I didn’t know the transistors needed to be electly isolated. So it tossed some sparks and doesn’t work anymore. Womp womp!

This was supposed to be A NO HALL CONTROL BOARD!! IT IS USELESS TO ME. I PAID A HIGHER PRICE FOR IT AND GOT SCREWED!! I DONE A SPECIFIC SEARCH FOR A NO HALL BOARD WHEN I PURCHASED IT IT WAS A NO HALL BOARD, PISS POOR DEAL!!!!

This product does not do as it says. I would love to know what it actually controls... if anything. It doesnt have true schematics or instructions with the device, which i do beleive is required. If wired/ installed as instructed via sellers remarks on Amazon, it either heats up to the point of failure. Or it immediately fails. How is this still able to be sold. Will NEVER buy again. I do not recommend anyone buy this either.

Motor is making lots of noise and pulsating motion, however When I picked driver board from other company, same motor worked with out any problem.

No heat sink burnt up piece of junk

Immediately broke after plugging it into a 36v supply honestly tragic </3

Pequeño, práctico y funcional, pero, no me gusta que no trabaje a 48v, no tiene disipador, ni conexiones de control, se las tuve que soldar yo y agregar un disipador. En general cumple con lo mencionado.

funziona bene .. bisogna dissipare bene.

Ich habe jetzt schon den zweiten Controller in der Hand. Beim ersten waren alle Fets falsch herum eingelötet. Daher habe ich diesen zurück geschickt und extra bei einem anderen Händler einen weiteren Controller bestellt. Das gleich Spiel. Alle 6 Fets sind falsch herum eingelötet. Da ich das Ding brauche und nicht noch mehr Zeit verlieren wollte, habe ich die FETs selbst gedreht. Nach ein paar Sekunden Motordrehung bei 24V ist die Platine dann schließlich völlig ausgestiegen und ich kann das Ding in den Müll werfen. Ich war schon skeptisch durch die vielen anderen Bewertungen. Da die Alternativen fehlen, habe ich doch bestellt. Leider hätte ich das Geld auch gleich verbrennen können. Ich habe bereits viele Platinen aus China verwendet, von denen einige ihre Problemchen hatten. Das Zeug hier ist dagegen der blanke Schrott. Sorry...

No tiene gran calidad de construcción

Have bought 3 of these. Two of them was malfunctionakl. The third one died after 1 min use. Totally crap. This is a scam.