Vibra-TITE 213 VC-3 Threadmate Threadlocker, -65 to 165 Degree F, 5mL Tube, Red

Had great luck with this stuff... it's just EXPENSIVE. But used it on a bunch of stuff and had no issues. Works as advertised!

Way better than blue loctite. Clean your fasteners before use. Apply to threads. Let cure for 30 minutes prior to installation. We use on all out club firearms and air guns, as well as archery equipment.

It works but close the jar fast or it can dry out. It may be better to buy the smaller squeeze tubes.

Worked well on my pistol optic and shotgun stock screw. Before Vibratite, I was using the usual loctite blue but that did not stand the vibrations and jolts caused by a 10mm pistol and 12 gauge high brass shotgun loads. So my optic came slightly loose and lost its zero and my semi automatic shotgun had its stock loosen after 100+ shells shot. I then tried out the vibratite on both my firearms and went back to the range at least three times to confirm that it works and is better than loctite blue. It is confirmed. 10mm pistol optic holding zero perfectly now with no evidence that the thread locker is failing. Same with the shotgun, with the stock being firmly set and secure with no evidence of it coming loose. So, vibratite is good for firearm purposes

This stuff is great on my RC cars. Make sure you keep it off the threads of the cap or it will lock closed on you.

This stuff works great for most thread-locker needs, but it's easy to ruin the bottle getting the cap stuck on. I've found a few wraps of teflon tape on the threads when you first get it solves this problem and saves a lot of headache later.

This is the best threadlock on the market . It remains pliable & can successfully be loosened & retightened several times before a need of reapplication .

Absolutely love this stuff for screws on all of my firearms gear. I find this works so much better than blue loctite, so anything that has screws gets this. Accessories, optic mounts, flashlight mounts, anything. As long as you clean the threads after use and before you cap it back, I haven't had much issue with mess. You can cut the tip to be as small and precise as you want, and for my use of firearms equipment, it's enough to last for a while.

Works really well. Locks the threads but still easy to remove.

It's good

Small quantities, only air in the tube

This product makes bolts & nuts secure from loosening against vibrations. It is easy to put appart and reuse not more than twice.

This was recommended to me for use on rifles where blue locktite just wasn't keeping screws from backing out. I tried it on a couple particularly troublesome pieces and it has so far held tight past the point where the blue would have failed.