14 oz, 2-Pack, Almond, Stop Leaks Instantly, Waterproof Rubber Spray On Sealant Coating, Perfect for Gutters, Wood, RV, Campers, Roof Repair, Skylights, Windows, and More

This product works well. I used it to cover the tops of dock pilings. I recommend it.

I used this to seal a leak in my concrete fountain. I was a bit hesitant having only seen it on TV commercials and no one else's experience. I cleaned around the crack, sprayed 2-3 layers over it and refilled. It's been several months and no leak.

Left no room for doubt that this is liquefied rubber in an aerosol. Be careful to get the Right Tool for the job. Check their "store" on Amazon- interesting discoveries there. For waterproofing / moisture barrier I would consider this again if a thin layer is adequate. May need to develop some application "technique" in some instances. My unusual situation involved some gaps that were worse than I anticipated. It's thin. Layering onto partially dry base layers to bulk it up did work but it's tricky until you find the way. I should have had silicone caulk on hand too but this seals hairline gaps nicely. With clear version, it's hard to see what's happening & to avoid waste or a running mess. Clogging is not a problem you'll likely have. As you might expect, liquid rubber involves intense solvents. You cannot over ventilate when using this. Plan ahead if using indoors.

Package instructions suggest eye, nasal and skin protection. I just used this and while using protection, didn't find an issue. Product didn't spray excessively but covered what needed covered. Was easy to use and not alot of mess. No odor. Dried well and did fill the holes.

While not perfect for every application, Flex Seal actually does what it advertises. After reading a lot of the one star reviews, I can see there are a lot of problems with the way people are spraying the product on as well as issues with what is expected. Here are a few tips to get you the best results you can out of a product like this (there are many and they are all basically the same) 1. Choose the right kind of Flex Seal. This may seem obvious but there are several kinds of flex seal and they are all used for different things. I. First, the rubber patch/tape is used for large cracks and or holes where you have full access to the area around it. The tape is very thick and can sometimes be unruly. Lay it flat out, cut it, and then roll it while keeping tension on or slap it on like in the commercial. Do not think you are going to move it around and reposition it. You won't. It's a one shot deal for best results. The tape, size to be at least 3-4 times bigger than the hole you are trying to close up. The tape can handle the most pressure in the product line. You must have enough surface area for the tape to get a good grip around the hole if you plan for it to take any kind of real pressure. II. The roll-on stuff is great for large coverage where you want to get fancy putting on thicker and thinner coats here and there. It applies like a sticky paint. I would say that the paint is the most "accurate" because you will use a roller or a brush to put it on and you can make sharp lines, stuff more material in gaps really easily, and handle uneven surfaces nicely. III. The spray is for quick easy jobs as is the weakest under pressure. It's great for sealing things like sky lights, thin plastic objects, joints on gutters etc. Anything that won't see a lot pressure behind it. It's harder to put on thick, but if you apply it like spray paint you can do amazing things with it. Thin, even coats, in a sweeping motion, over and over again and you can cover just about anything. IV. The flex seal one shot caulking is really just like almost any rubber/silicon caulk. I've only used it once and was not all that impressed so I tend to stay away from this one and use 3M stuff instead. 2. Pick the right color for your application. The Clear does NOT stay clear. It has a tendency to turn yellow in the sun. If you don't mind that, or won't expose to sun or much light, then the clear is fine, however, I usually stick to white or black. PRO TIP: You CAN mix the colors of the roll-on to make different levels of gray. I am sure Flex Seal would frown but it works for me. It takes a lot of churning to get it all mixed and not streaky. Your mileage may vary. 3. Use for the right jobs. Don't expect this to seal high pressure water or stop a leak in a tire. There are limits to its flexibility too. When you can, seal from the inside AND the outside. Use the tape whenever possible as it works the "best" of the products and is insanely tough. 4. A little goes a short way. It doesn't cover as much area as you would think. Always get extra. 5. Using a screen door in the commercials wasn't an accident. When covering a large area, stick a screen type material to the area and screw it in place. Then use flex seal to cover the gaps in the screen. Use many coats, go slow and the kind of gimmick you see in the commercial is possible. If you cut a 4 inch by 4 inch hole in something, don't expect flex seal alone to seal it. Use a backing material. 6. If you are getting bubbles in the flex seal spray you are putting it on too thick. Relax. Put on thinner coats and apply slower. Give it a few minutes to get tacky, then retry. 7. Final PRO TIP: CLEAN THE APPLICATION SURFACE. This one is a no brainer, but over and over again I read about people not doing the prep work. Using de-natured alcohol is best if you can. It leaves no residue and on a clean surface like that it makes Flex Seal stick like you wouldn't believe. This is the most important thing other than choosing the right kind of flex seal to use IMHO. Good luck! P.S. One more thing you can do is use painters tape or the like to cover from over-spray. Really if you treat it like a super thick paint, most of the same principles apply.

I guess this product works okay. But order four times as much as you think you'll need. I have a small Hut with just four asphalt shingles. To prevent the asphalt pebbles from falling off, I thought I would seal them in with this. Two cans didn't do it. That's pretty unbelievable. I wish I'd ordered four

Fabulous product ! My ceramic outdoor barrel-style fountain developed a leak. I sprayed the Flex Seal on the inside and the problem was fixed immediately. No more leak and I can enjoy my fountain again.

Worked great. I had to use 2 coats, but this is so easy and it sealed the area almost instantly. Will buy again!

Good

Le gustó a mi esposa porque le sirve muy bien para los trabajos que realiza

Produto resolveu um problema entre a calha e a parede evitando escorrimento de água da chuva mostrou-se mais eficiente que o veda calha. Esperar para ver a durabilidade do produto sob as intempéries.

Big talks & no performance

La verdad, mejores resultados a los esperados, selló muy bien las grietas que me Quedaron después de instalar techo de madera en la terraza , resiste espectacular