SANUS Full Motion TV Wall Mount for TVs up to 90" - Premium Design Extends 24" with Fingertip Swivel and Tilt - Easy 20 Minute Install - OLF24

Love this product. it is on the expensive side for TV mounts but in some cases in life you actually get what you pay for and this is one of them. I can't say enough about this product. But in summary it is well made, and the most flexible 2-studded option that I could find. I read a lot of reviews for other mounts before buying this product and I am not disappointed. Pros - Super high quality. Well made construction. Feel sturdy - Everything you need (screws, etc.) is in the kit (except for tools of course) - Installation is very easy. I did it by myself mounting a 50" LG UH5500 LED HDTV. Installation took me a couple of hours but that included planning out where the studs were where I wanted the wires to run and other things. But I would say just doing the mount itself took about 45 minutes after quickly reading through the instructions. Instructions were very clear - The best thing about this mount is its ability to slide the TV left or right after the mount is installed. This was HUGE since my studs did not line up with the center of my wall. The tilt up and down, swivel left/right and shift left/right made this this hands down most flexible mount that I could find on Amazon IMHO - I only mounted a 50" TV but i feel this thing could hold a lot more. No droop or sag whatsoever with my TV that weighs about 50 lbs - You can go to their web site and plug in your TV model to see if it fits the mount - Low profile so that you can fully pres the TV against the wall and not see lots of metal or wires. This was a strong requirement for me - Two-studded installation means it will have good strength. Fits studs 16" apart and a little more Cons These cons weren't huge for me but I should mention them ... - Two-studded installation adds strength but can also be a little less flexible if your studs are not the correct distance apart. This was not an issue for me as my studs were 16" apart which is standard - My TV is the LG UH5500 LED HDTV. It is VESA 200 x 300. The Sonus web page for this mount lists this mount as supporting 200 x 300 however my specific TV is not listed when use their TV compatibility tool. (I didn't know about or check the tool until after I was starting the install). So for me ht bracket for the TV could only fit if it overlapped where some of the cables plug in. The cables that were blocked were component and optical which I don't plan to use bu this was almost killed my install for a moment. And note that their instruction manual did not show a configuration for 200 x 300 so I kind of figured out the best arrangement on my own. All in all it worked but like I said overlapped where some of the cables might have gone. So definitely check your TV for compatibility on their web site if you want drama-free installation (I added a picture to show how the bracket overalpps for my TV) - They provide some plastic clips to hold your cables but i found them to be only slidghtly useful and not that strong. Would have been nice if they were a little more hefty and connected on more firmly - Cost is more expensive then some other options but I think it is worth it for what you get Overall I am happy with the purchase and would buy again!

I researched a lot of these before I made my purchase, looked at all the negative reviews and can't understand some of them but as for the product itself I can't see not giving it 5 stars. I was going back and forth about a 2 arm mount vs the 1 arm and this Sanus is built like a tank. My tv is a new Sony 65 inch with 300x300 mount formation and this will adjust to any size out there. It has all the hardware you need and as with the other reviews make sure you mount INTO WALL STUDS. Mine are 16" on center but I got the 24" on center so I had some wiggle room to center it and I put in 4 extra wall anchors because I'm obsessive like that, worth the extra cash. Only tip is that when you pre- drill the pilot holes I like to go a little smaller than recommended diameter drill bit AND put a stop collar or tape on the bit and drill it a little shorter by 1/4", that way it has more wood to grab, which is the reason why it will hold solid, also hand tighten with a socket, it's a little harder but that lag will stop solid when it's all the way in. I don't think it extends the full 24" unless it's to the front of the tv but I don't need that. It sits out about 3" from wall when flat but it still looks good, and gives the tv room to breath, wires sit nicely hidden and neat along the arm. It can take a little time to level the tv when mounted but not a biggie, I leveled everything from the install up and still had to level the tv after mounted, and make sure with a big tv to use 2 people. All in all a great buy, brother buying same one for his 60", worth the extra $20 or so for a great product to protect my $2000 investment.

Works perfectly for my LG OLED65C6P! The G6 that someone else had an issue using this mount with has a different design where the mounting holes are closer to the bottom of the TV. The C6 has them higher up, so the mount is perfectly hidden behind the TV. I love the range of motion that this mount affords. I keep my TV extended out the full 18" most of the time, but it's nice to be able to turn it to face the kitchen while cooking, pull it out to the side to access the connectors more easily, or put it back on the wall when messing with my HTPC down below. The tilt adjustment works very well, too. My only complaint is that this mount doesn't have an adjustment that can be used to make the TV level after installation, so it is absolutely critical to get the wall portion of the mount exactly level. Even after doing that, I found the TV didn't end up completely level. Perhaps I didn't mount the arm to the wall piece correctly. I was able to make a small leveling adjustment by loosening the screws between the mount and the TV, and holding the TV up on one side before screwing it back in. There is not a very big range of motion for this, and I wouldn't recommend depending on being able to make this "adjustment". I used the biggest spacers to make the reach of the mount that much bigger, and they may have made this "adjustment" work better for me.

Very happy with it. Worked with a TV that wasn’t listed. Great quality, durability and flexibility.

Very strong and solid looking tv bracket. Reality good for any tv till 90 inches. Great product and I highly recommend as it is full motion and can fit any tv

J'ai mis beaucoup de temps à trouver un support qui faisait 60cm de large pour atteindre les deux rails de placo afin d'être sûr de la solidité de fixation du support. Installation facile : J'ai utilisé 4 chevilles Fischer qui se rétractent dans les rails et 4 chevilles molly dans le placo. Les mouvements sont fluides et les réglages d'angles également.

Holds the 85” Samsung. Not what I would call easily moveable based on the tv size. But I’m leaving it in place, I only need the tv pulled out to get cables in/out as they are 500mm in from the edge. If you move the tv you need to re-level it, seems that no matter how tight I put the nuts it still adjusts slightly - just based off the tv being so heavy. Handle that you rotate to adjust height doesn’t extend long enough to be below the tv so it’s not really adjustable when on there. Overall - solid bracket, happy enough with it.

Wall mounted 65 inch Samsung 4K TV above fireplace. Works great.