Cutler & Hammer CHSPFMKIT Flushmount Kit

Nice product, I would be comfortable purchasing again from this company.

Fits surge protection unit perfectly.

Plate is to small no room for error. So if you cut the ears off surge protector you can make it fit with out cuting drywall out and replacing with a new piece. Double sided nano tape and it stay in place it hold 40 pounds. Just be careful that tape is strong it will rip a hole in the drywall if you try to remove it

I was planning to make these myself because they are ridiculously priced for what amounts to a metal cover plate with an odd shaped hole in it. However, time ran out, the inspector was coming and I wanted to have them in place. I have to admit that they are well made, fit nicely, and look nice. Amazon’s prices were better than any electrical supply house by a factor of 2-3, they arrived quickly and I can now move on to the next project.

I sent this back it will not work for me at all a really poor design. It is BARELY larger than the Ultra maybe 1/4 inch on the sides unless you cut the screw holes off the surge protector as some suggest (voids any warranty im sure) and why would you cut a brand new item???? so with this plate, you have near ZERO room for error in your drywall cut and there are no provisions for using this flush mounting plate to secure your surge protector to the drywall and if you instal under your load center using a knock out the plate is in the way of the panel front unless you notch the panel front (you cant do that dont do that!!!! ) a very poor design, it is a pretty expensive piece of metal about the size of a double box switch plate cover and is useless to mount the surge protector as it is made. Also, as others have said, the provided screws to attach the plate to the surge protector are WAY to short to use unless your mounting under / side of your load center puts the surge protector exactly flush with the drywall the screws are less than 1/2 inch long most drywall is about 1/2 or 5/8 inch thick so again, like others have said you have near zero room for error. If you need a recessed mount the Eaton is pretty hard to make work and this mounting plate is not a great solution at all it more of a cover than a plate.