HQMaster CNC Router Bits 1/8 Router Bit Straight Router Bit 1 8 Shank Straight Flute End Mill Cutter 2-Flute Milling Cutting Tungsten Steel 22mm CEL/45mm OAL for MDF PVC Acrylic Chipboard Wood 10 Pack

I’ve had some pretty big disappointments when buying cutters and bits made in China. They were poorly made and dull out of the box. Not the case with this one. Thanks to the positive reviews on this cutter and the very reasonable price, I decided to give it one more try. I needed the cutters but didn’t want to pay the high price that Dremel wants for their version of the same thing. Right out of the box, I was impressed. They are well machined and very sharp. I used a single cutter on this entire project, to lower the depth of the lattice design 1/4”. The wood is Mimosa appx 10”x 15”. I did it in three passes, increasing the depth each time, for better control, to prevent tear out and to prevent overheating the cutter and dulling it. It cut clean, left no fuzz and a smooth, easy to sand finish. One cutter did the entire job and though I could tell right at the end it obviously wasn’t as sharp as it was in the beginning it was still doing a beautiful job and has some life left in it. Don’t be afraid to give them a try. Hopefully you will be as pleased as I am.

All good :)

This is a good bit with some specializations. Run this on a Shapeoko with a Bosch 1617. Feeds at 100IPM with a 3/8" DOC at full RPM. Works extremely well on thin plywood (1/4") as you do not need tape to hold the board down, since the cutter will not pull up like it will with spiral flutes. On thicker materials, such as 3/4" ply, you will wind up with a layer of compressed sawdust holding the part in place, which makes cleanup a touch more difficult, as in some instances a screwdriver is required to separate the dust from the cut, but the edge quality is extremely good. Longevity is a tad short, like most of the HQMaster bits, sometimes the bit will go 10hrs or so of straight cutting before you notice signs of dulling (rougher edges, more RPM loss when cutting, etc) and sometimes they will shatter.

No complaints on these bits at all. They are sharp and cut through soft wood with no issues. I'm running all of my 1/8" bits at a very conservative feed and stepover but did manage to screw up on feeds on a deep cut and broke a bit. I feel this is my fault vs the bits though. Recommend if you're looking for an economical set of end mills.

I used them and cutted ca. 5 hours with my CNC until I had to change.I had better and worse straight router bits. If they would be a bit sharper I would have given 5 stars. (Had ones normal china straight bits and they were so sharp that you easily could cut your finger installing them.)