Bosch T102BF 3 pc. 3-5/8 in. 13 TPI Clean for Plexiglas T-Shank Jig Saw Blades

These blades worked perfectly cutting 1/8 inch plexiglass sheets. I had no problem using them with my Wen 33606 at speed 3, orbital 3. No issues with the fit, they held strong.

These blades cut plexiglass smooth and fast. Highly recommended product and seller

Perfect for cutting quarter inch olexiglass

Finally got to use these the other day and I have ZERO complaints. I need a way to trim down some 1/8" thick plexiglass for a 3d printer enclosure i'm building. Using one of these blades and a Dewalt cordless jigsaw, it zipped right through with no hassle!

Worked

I used this to make a 36"-long cut in 3/8" plexiglas. My sense is that the cut was getting a bit rougher towards the end, but I may have been getting impatient. You really need to go slow. There were NO tearouts and NO chipping along the entire cut. -- The set and grind of the teeth is unique compared to other Bosch blades. You *are* getting something different for your toolchest if you buy these. I recommend.

Just got finished cutting a 9" circle in 1/8" thick acrylic mirror and it was perfect. Used a medium speed right off the bat (with zero orbital setting). Didn't use anything to sandwich the plastic, went nice and slow, and to be honest I didn't think a blade can go through plastic like that without melting. No chipping either. If fit slightly tight in my Milwaukee saber saw chuck, but it's better to be a little tight than loose in the slot. Glad they come in a 3-pack. Worth every penny, for me anyway.

Great blades, specially when using on acrylic

I am so happy I purchased these before cutting a large piece of plexi. The blades cut through the plexi like butter. They got a little hot but did not melt the acrylic. I will be using these for any plexi/acrylic I need to cut.

Before getting this I tried the metal blade method for the plexiglass and it got too hot and left a hot mess. Then I decided to get this plexiglass blade with this specific edge and I should have done so from the start! This made clean cuts and did not heat up! Have I done this I wouldn’t have damage my plexiglass :( I would totally recommend!!! Don’t try to save a few dollars by using the metal blade, just get this and you’ll have a better and effortless time!! This was from my experience using the master craft motor hand saw on a giant piece of plexiglass.

I used it to cut ABS sheets and did a perfect clean cut.Trick is clamping down the sheet.Set the jig saw to a medium speed so you dont melt the surface and do not rush the cut.I put some masking tape down just in case of tear outs.Never happen.Overall a quality Bosch product.

I just used the blades to make straight cuts on 1/8" thick plexiglass and it worked like a charm. The cut was pretty clean and would only need a light sanding if I wanted a smooth finish. It was slow going, but these blades are designed to be used on a jigsaw, not a bandsaw so I had to adjust how hard I pushed the jigsaw as it cut through the sheet. I haven't tried cutting anything thicker, but I suspect it would be even slower so patience is required. However I was able to cut large radius curves. Overall I'm pretty happy with the results.

Excellent pour le plexi glass