Capri Tools Tube Bender, 1/8, 3/16 and 1/4 in. (CP21105)

Bought to do some brake line repairs. It bends standard copper pipe really well. Just take it easy and don't rush it.

I wanted to bend some brass pipe to run some wires through for a project. As such it was important to affect a bend in the pipe that didn’t “crimp” the pipe to the extent that the cable couldn’t be run through it. I bought these as they weren’t overly expensive to see if they’d do what I needed - they did. I should also note that I heated the pipe up with a blow torch before using the pipe benders and bent the tube whilst it was still hot.

It done the small job I needed it to do, anything more I word get a more “professional” tool

Works very well. Can do up to about 100 degrees. Very simple to use. Highly recommend. Used for 3/16" lines and did exactly what was required

This tube bender works well for bending brake lines. Has good finish well made. It should last for years.

Even though you can bend 3/16 copper-nickel brake lines by hand - this tool gives repeatable, smooth, professional looking bends. Used this to do an entire car and had no issues, a great value for the money.

Lo compre solo por la posibilidad de doblar tubo 1/8, pero es muy práctico y se ha vuelto mi doblatubo principal, para tubería de 1/4 en refrigeradores y neveras.

Works surprisingly well for solid 1/4" rod. I mounted the tool in a vice and put a pipe on the handle to get leverage as the handles are quite short, but the result was better than expected. The tool is aluminum so it may not hold up to this kind of use. Only drawback to this is that the bend radius is fixed. Hard to measure but I would guess the bend radius for the .25" slot is about .4"