MuHize Low Profile Mini Fuse Tap - Upgraded Locking Clip Adapter with 5A Fuse for RV SUV Truck 2000-2025 Models | Anti-Vibration Design

Bought these for my dash cam install. Been perfectly fine for YEARS now.

These fit perfectly in my 2015 Ford Fusion Energi. The fuses are a little tight in the slot, but easy to seat and remove with some needle nose pliers. I used them to hardwire my dashcam to ACC and Battery. I also hooked up my radar detector to ACC. I used the bolts that hold the OBD port for ground. You can use the fuse diagram that’s in the glovebox on Ford vehicles to determine which fuse you can tap into for ACC or Battery.

Good item...worked as it should

The Mirco2 version Works on 2017 Hyundai Elantra engine compartment fuse box. You have to be careful that there is enough clearance in the direction you need. I used 2 taps, and part of a fuse, to change the power socket from Ignition controlled to Always on. I used tap #1 to get always on power from an unused slot. On Tap #2, because of the pigtail direction that was unblocked inside the fuse box, I had to jumper the pig tail to the power lead (left the fuses out, since there was one on Tap #1). I cut open a fuse in order to take the lead from one side and bent it into a U to jumper the two slots, then covered with electrical tape. Joined Tap #1 to Tap #2, and viola! Always on power socket. The leads on the included fuses were too wide to fit into the Tap. You would have to file them down to get them to fit. The fuses in the car fit fine. Also, two fuses would be a tight fit. The ones included had a wing on the housing above/below the amp number. That kept two from seating nicely. You would have to remove the plastic (cut or file off) in order to get 2 fuses to seat. The metal portion of the fuses seems to be aluminum, and easy to file and bend.

They are add a circuit, what are you expecting? Fuses fit VERY tight but do fit, so if you are having problems.. get stronger. I am using 3 of these in a turn signal mod which I need to tap into the trailer wiring of the bcm. The fuses are right next to each other which caused an issue with how the wires come out of the side (can't find any that exit straight out) so I had to modify those to work but when doing mods, you gotta mod things to mod lol

When working on my GMC truck to add a hard wire radar detector. I didn't know that it used Micro2 fuse. My local auto store didn't have them. So I went looking around a found then here on Amazon. The Fuse tap work perfit and made the job easy. Well worth having in your tool box.

Great quality for the price. No issues at all

Problem solver in some applictions.

Used on my truck for lights I added and I am fussy on how wiring is done I don't want problems down the road. This is a very clean and neat way to get job done without damaging any wires

Easy to use and they work very well, saving a lot of time and effort when adding a dashcam.

I purchased this kit to add a circuit to my car's fuse box, but unfortunately, it didn't fit my vehicle. The connectors didn't align properly, making installation impossible. Before purchasing, I recommend checking your car's fuse type and compatibility to ensure this kit will work for you.

The listing stated it is a micro2 blade fuse tap. When item arrived, the label on the packaging also started that its micro2 blade fuse tap but the actual item is a mini blade fuse tap. Disappointing that such an error can occur.

Great value, appear to be of good quality.