12" inch Slim Fan Pull Electric Radiator Cooling Fans 12V Mount Kit Unversal Black

Blows air like it should. Been in for 6 months.

Actually used this as a fan for my riding mower. I had put a top on the mower, and I seen where a lot of the newer mowers had fans. Mine needed a fan too, so I got one and made it work. Works very good.

It's a 12V automotive fan. Nothing more, nothing less. I use it as a cooling fan for my shed run off solar power. It moves plenty of air. It appears to draw more like 90W on my setup. It comes with a good set of mounting accessories not useful for my application but good if used on a car radiator. For a shed or attic fan application on solar power It is a great value.

This is a 1yr follow up review from purchase date. I installed 2 12-inch fans on a W22 workhorse chassis RV to replace my auxiliary fans. OEM parts were not available from the maker, so I decided to go with this as an alternative. They were very close in Fit to OEM fans. With anything that's not OEM I had to do some modifications to the mounting bars so the holes line up & slightly adjust the bar. I used (Ancor 211428 Marine Grade Electrical Nylon Insulated Double Crimp Funnel Entry Fully Insulated Disconnects with Insulation Grip (Female & Male, 12 to 10-Gauge, 25-Pack) from amazon to connect old to new wires. I did not have to use the provided mounting hardware due existing mounting setup. The fans are powerful. Noise level wise I can hear them when they turn on. This is good for me to know if I don't hear them then something is wrong. They operate as good as the previous fans & still functioning 1yr later. The price point & quality are a plus.

Easy install. Good speed and quite small One wire goes to ground. The other to power. I like man ran full speed on ignition. So I ground off one and route other to ignition on using the fuse box . Use these on all my cars I get. Just to have extra cooling.

Worked great as a replacement on my Workhorse W22 motorhome chassis. NOTE: It does not line up exactly as the factory fans... I used one bolt from the stock and zipties for the other hole. Alternatively you can drill a hole in the mount of the radiator to make it line up. 1 bolt on top and bottom will line up, and simple ziptie will hold the other side.

This 12" fan has about 1/3 the air flow of the GM factory 12" fan I had been using. It is still marginally sufficient for my purposes and it is a LOT quieter than the worn out, squeaky, 28 year old fan it replaced. If maximum air flow is important to you DO NOT buy this fan. It has, at most 1/2 of the claimed air flow. All in all, considering that it is relatively quiet, inexpensive and the air flow just good enough for what I am doing, I will give it 3 stars. But I have only been using it for a couple of days. I have no idea how long it will last. I suspect that my worn out OEM fan probably still has more life in it than this does.

I really like this fan. I installed on a 72 El camino to ditch the mechanical fan. I got the 12 inch and it fit great. It pulls low power like 8 amps. Moves a decent amount of air. My car is a drag car so it won't see traffic, but so far I just turn it on when I start the car. Ran to a toggle on my race plate.

As described.

Se ve de buen material, y no se escucha desde la cabina al momento de encender, se le adaptó para el aire acondicionado solamente, de consumo creo que le jala menos de 10amps, no le afecta al alternador, pero sí un poco al radiador del agua ya que arrancando en frío tarda el motor un poco más en llegar a temperatura óptima de trabajo, pero éso ya es tema aparte, lleva un año de uso y sigue funcionando.

لا بأس جيده

Works but does not move a lot of air.

Ventilador funcional pero el empuje del aire es regular