xmartO 10X Zoom Dual Lens PTZ Home Security Camera

When I first bout my xmarto cameras back in 2015, it was only a 4 camera system and those cameras did actually reach 1000ft. I had 4 cameras at my house and 4 cameras 1000ft away at my pond. But the problem I had was I had to switch from HDMI 1 to HDMI 2 to see the different cameras. When I seen they came out with a 8 camera system that was suppose to work better, I wanted that so I could see all 8 cameras on one HDMI cable and not have to switch back and forth, I bought more than one and bout bigger antennas and barely got 200ft. But every camera system they made after that you could no longer detach the antenna and add something bigger so I didn't want to waste my money getting any thing newer. The only thing about these that got my attention was the wifi 6 I knew it was a better wifi connection so I figured Id try them. I have to say I am impressed. I get a little better range than the others but I dont need the long expensive cable and bigger antennas to get a decent signal, I was able to take all that down. So far the longest range camera I am able to try is 230ft and Im getting 2 bars on that. It never cuts off ...the signal is constant. I have a 2 story brick house and im getting signals all around the house, the ptz movement works well on all of them, the audio and speaker works well on all of them. The only thing is they get blurry if there is not enough light. If you connect near a night light and turn off infrared you will see good at night. Or if you do not have a night light and want to see further in dark and it be more clear you need to buy a infrared light to put next to it to light up the area more, again the more light you have the more clear the image will be at night. In a dark area with a good infrared light pointing in same direction as camera I can see about 200ft out, its a little blurry but I know when something is out there moving, again the more light you have the better and further you can see. The human or animal detection works ok, I have most of that turned off but I did have it on for my cows, it followed them some when they got close not the best and not something I use or need. I do wish the antenna on nvr was bigger but I have to say with 10 cameras surrounding a 2 story brick house I get pretty decent signal. Def worth getting, I wish they actually went over 1000 ft like they say but they only happens with the 4 camera system in 2015. Hopefully they come out with something new that does go that far so I can cover my whole property of 7 acres. But for around the house, they are good enough. Not once have they cut off from poor signal even when there is only one or 2 bars it still shows smooth video no skipping around or cutting on and off so they are worth it. It just doesn't go 1300ft, they need to make some that does and actually make a test video proving it goes that far before we waste our money, but for this system..for around the house and less than 300ft they work good

Great camera system

I WAS happy with this system from May, 2023 when I bought it and installed it. It worked fine for 8 months, until the cold months arrived and now, 8 months later, the cameras won't stay connected or keep the settings. I've tried everything and sent messages to help center and no one replied. Some cams come back on line after a day or two, some never come back on line. I've performed resets and had everything checked out by my Internet provider. One tech thinks the NVR is going out. Either way, I am not a happy customer or fan of this product. Waste of time and money. Update: I've contacted product support multiple times and I just get the runaround. They just keep telling me to perform the tasks as I have done. They won't admit that I have 2 bad cameras. One email asked again for my address so they could send new cameras, but I ask and ask for a shipping tracking number and when I can expect them. Again....NO reply, just keep me in limbo. This has gone on too long. I'll find a better security system and report this xmarto company to the better business bureau and FTC. This so called warranty is a scam!!!

I install CCTV as a large part of my job, I’d say this is one of the better residential ones on the market, and you can definitely not beat the quality for the price. I blocked out 5 hours on a Saturday to install the system, it took me an hour and that was only because it was raining, otherwise much quicker. I recommend 1st plugging in the HDR and hook it up to a TV or computer monitor and then installing the cameras I came in to check each one as I installed them. PTZ and all the functions are super acurate. Overall this is a great system and in my location there’s not really obstructions so I was able to place the cameras beyond the recommendations.

Pro: good picture quality on pan tilt and zoom camera, no network cabling needed, excellent wireless range Cons: powered cameras do not seem to be made for outdoor use, human body detection is poor (Side note – I have used and installed other DVR/NVR cameras and systems including DPro, Hikvision, and others) I liked this system because it has its own Wireless camera network. When dealing with a large multi building facility, running wires is impossible. You can wire the NVR to your backbone switch or it can be run wirelessly and then the cameras connect to the wireless network on the NVR not your local WiFi. The range, without the repeater, is very impressive. A repeater is available and easily connects to the NVR without manual configuration. There are wireless/solar cameras that you can get for this NVR, but I just got the wireless ones that require line power. The cameras have a changeable wall/ceiling mount which is nice, but this part of the product could use some revision. When you remove the mount and put it on a wall, the camera and mount top both have open areas to collect water. This is problematic in the winter if water freezes in there as it will break the camera enclosure. I used some of that waterproof “flex-tape” to try to cover over it. Time will tell if that is successful. On normal outdoor cameras, the wire is routed back into the mount and the camera is usually mounted on a jbox. This keeps the wires inside where they are not exposed to weather and cannot be cut. These wires are draped below the camera and then have to be run through some type of penetration so that the connections are inside the building. This camera has a compound cable with an ethernet jack and power connector, so all of those need to be protected. The cable is pretty short, and you need to be sure to have a drip loop on the cable. For a shed with just siding and no insulation or finished wall thickness, I purchased these little electrical fittings from Ace Hardware. I had to ream the inside of one of the pieces to be able to push the ethernet jack through. I then mounted the fitting on the siding tightened it down. Inside the building, I could plug in the power cord and run to an outlet. Doing this on a building that has a 4” or 6” insulated wall is nearly impossible as the cord is very short. I ended up putting a jbox in the wall behind where the camera was mounted. To configure the NVR and cameras, you will need a computer monitor with either an HDMI or standard VGA 15 pin connector and a USB mouse. The local UI is a little clunky when you have to type on the screen computer with your mouse, but for most drop-down fields, it is not difficult and does not take too much time. It finds the cameras instantly without any effort. That said, configuration has some bugs. I tried taking the NVR off DHCP and setting it to a static IP outside the DHCP range. No sequence of setting, saving, and rebooting could get it to change. I gave up and left it on the assigned IP, though I did still disable DHCP. Since it seems to always come up on that same IP, I left it there. The reason that the static IP is important is that I then enabled DDNS. I started with a free name from No-IP, put in the settings and verified it worked. I then contacted my ISP (since I have a managed router) and got port forwarding enabled for port 80 to go to that IP. Once I confirmed it worked, I purchased the DDNS from No-IP. I did try another DDNS (one that was on the drop down, but I don’t remember which) and could not get it to work. I can now use my browser and go to the NVR configuration when not on site. From a security standpoint, I am a little nervous about that, but I did put in a firewall so the NVR is not near anything else. The browser-based configuration is easy, but like the local configuration, does not always work. When asking tech support, they told me not to use the browser-based configuration. Some of the configuration items are counter intuitive, and the names of them don’t make much sense, and there is not much of a manual that explains anything beyond telling you the label on the checkbox on the screen. Remote configuration is one of the primary reasons that I would buy an NVR system, though, so I keep trying. I also set up the PC app and the Android app. The android app is probably the easiest. It installs quickly and did allow me to have several different people create their own accounts and still get access to the camera system. The iPhone app seems to work well, too. The apps are very capable for viewing the cameras live and even has the pan-tilt-zoom ability for those cameras. The app can also get alarms on human body detection. This feature does not work very well. It triggers on everything. I lowered the sensitivity to lowest, and changed it so that it had to see movement for more than 5 seconds. I was still getting hundreds of alarms a day. Next, I removed all areas in the view that had leaves (no more pan and tilting). That helped a lot. I got down to a couple dozen alarms a day. It still seems to trigger on the movement of shadows on the ground from the trees on sunny and windy days and I have not been able to eliminate that. It definitely finds vehicles, humans, and lots of wildlife which I don’t mind at all. I am told there is a firmware update. I have not tried to do that yet, so I cannot tell you how difficult it is and whether it helps any of my issues. The PC app can be used to download the videos from the trigger events along with the time-based videos. Doing it remotely is slow, but I have slow connections on both ends, so that is probably unrelated. You do need to go into the configuration in the app and change where it saves the videos though. The default is in a protected location on your computer hard drive so access to that will be denied. Change it over to “My Documents” or “My videos” and you will be fine.

So far, and it's only been a couple of days since I installed this camera, everything is OK. Plugged it in, in the house next to the NVR and added the camera to my system, then mounted it outside, under an eve. Is working fine. I tested the PTZ and it is working also. I do not have notification on as I have six cameras and don't need to hear any of that, we have a monitor and can watch everything from the family room. I checked with the app that I have and it shows up there also. I did not put a SD card in the camera as the NVR has storage of a 4 TB hard disc. I bought the other camera in the system a few years ago and when going to purchase again, they were no longer available but this on showed up and the price was right! I had no problems connecting.

this is the most expensive camera I have ever bought. but there 4 cameras in the box! it is the best camera I have bought It comes with an NVR, It must connect to the computer, I don't use the NVR, I just installed the camera near my garage. Download the Wallpixel app on my iPhone. and then follow the instructions the camera will connect to my phone! It would be best if you put an SD card in the camera. otherwise, you have to pay to use the cloud storage. the camera can turn around 360 degrees from up and down or left to right. the best thing I like is when you check the playback it shows when there is a screen movement and a human appears, so you don't need to check all the videos by each second! It also comes with a motion detection alert you can set up a motion detection area and motion detection period This camera is great. thumb up! I just installed one camera in my garage, I will install the rest 3 when I have time.

Had to change my review. The crappy android app "pixelwall" used to remote view now only has 2.5 days of alerts. It is constantly switching t "cloud mode" and warning you should subscribe. I bought this so I wouldn't need a cloud storage service. It is constantly nagging with advertisements sliding into view to sign up any pay more money. Very impressed with the wifi6 dual band and camera wifi repeaters. Also color night vision is great and works almost as good as the IR night vision. The cameras are all 2 megapixel but very good quality; one is 1x zoom with a nice 130 degree wide angle, and the other is 4x optical zoom and it switches between the cameras as you PTZ zoom. The other zoom ranges between 1-3x and 4-10x zoom are digital. The wifi6 has ALL of the DFS channels that are usually unused because most devices don't certify the DFS channels. You can easily find an unused channel 116-132 for example that no routers are using. The channels are 1 stream, 20MHz so bandwidth is 143Mbps for all of your cameras and repeaters. The PTZ cameras have a unique mounting plate that can be used a few different ways. The human detection is useful when playing back video so you can just show people. The android app worked great after setting up an account and allows full management. Events and full timeline of video can be found and played from the hard drive at 1X speed only - but it first defaults to cloud so you have to change to local to see the controls. It sometimes gets confused with the zoom when changing between cameras and stops zooming. The cloud service is $1.99 per month PER CAMERA if you want it, but it is not required. Update: I found out microsd cards aren't supported when using them in NVR mode. They will only record do the hard drive or the paid cloud service.

Not good as described .