Spare Tire Brake Light

good quality. very small amount of fab work to make them fit my 2001 wrangler. just drill mount holes.

Edit - Once I drove the Jeep, I discovered that this light causes the door/seatbelt warning speaker to buzz every time the brake pedal is depressed. I will update if I find a fix. No fix found. Nilight made it easy to return. It seems to be an issue with my Jeep's electronics. All other options I tried also caused the buzzing sound, so it was not the fault of the light. My jeep did not have a connector for the third brake light, so it didn't matter that this one had to be wired in and didn't have connectors. Looks great in the spare tire on my 2017 Wrangler Rubicon JK. A previous owner had replaced the "eyebrow" third brake light over the spare tire with a small LED light that replaced the center cap of the spare. Adding this ring-style light into the circuit was simple, and greatly increases the visibility. I used a small amount of black Permatex RTV sealant to hold the plate of the light onto the spare tire mounting plate so in the future when I remove the spare, I will not have to worry about the brake light falling off.

Left side is new, right side is old. (The old is similar to this look but not the same brand) Installation was easy, I highly suggest putting the bracket together as much as possible before clipping it in, I can’t remember details of how I did it now but that will make sense if you’re putting it together. Great value for the money, absolutely love the appearance! Brightness seems great, fit is perfect on the 2014 Wrangler. Wiring all fit easily and easy to put together.

Works well, but you have to be careful on the install. The wires may come apart at the soldier points if not careful

Product as described. Excellent price. We purchased for a 2011 Jeep Wrangler and they fit perfectly. Easy to install. Why did you pick this product vs others?: The look of the lights and the price. We thought we'd give them a try.

Pins are bent on the inside, i had to return one set and get a new one, second set same issue. - To Fix: Use the old plug-bulb taken out of the old housing, and hold side to side to match up the positioning of where the pins need to be bent to. Additionally, once finally plugged in, the plug does not click into place and you have to force it extremely hard to make the connection in order get the light to light up. Clip fitment of the light housing into the fender-well is also off, i had to shave some of the plastic of the light housing with a razor blade and bend the plastic tabs on the drivers side in order for it to properly and slide into the fender-well shield. If you have this problem, make sure only bend the (two) tabs slightly and gradually or they may snap off. Maybe heat with a heat gun slightly before bending out of precaution.

1994 Jeep Wrangler YJ. 15inch rim. Fit perfect. Worked as described. I tapped into the factory third brake light. Biggest Takeaway, black factory wire is positive white wire with black stripe is negative. Took me a little while to figure that out.

I have mine behind the polished aluminum rim rear / spare tire of my Jeep JKU. - I have gotten quite a few compliments one how good it looks, mostly when seen at night. - With this lit up, they should really see you, when you are stopped in front of them!

Me gustaron mucho.

Third brake lights are as advertised!

The only real reason to get it is Cool Factor. It will make braking more obvious to people behind you ... But it just looks cool, we figure. Super simple to install. Takes longer to get the part off to get to the wires (like eight bolts).

Muy padre y es tal cual la foto, fácil instalación me gusto bastante

Came well packed and well insulated from moister. Living in BC, that's very important. The lights are stunning and very easy to install. I would absolutely buy again.