Pridefend Bolt Catch Pin Install Removal Tool Kit Starter Punch in Tin Case

Perfect worked great when I needed to replace my bolt release on my AR.

This tool makes swapping out a bolt catch very simple. It’s well made, and a nice length. The rubberized coating is great, but I still highly recommend taping off your lower if you definitely don’t want any scratches. This tool is made to remove and install the bolt catch pin from the stock end, which is exactly how it should be done. The pin should not require much tapping force during removal or installation. In most lowers when the pin is being removed, it will want to push against the mag lock protrusion on the magazine well. To eliminate damage, other than tape, I place a thin guitar pick (or similar item) under the pin and over the protrusion as it starts coming out, then lightly keep tapping the punch as the pin slowly rides up the pick and frees itself. If done correctly and slowly, it eliminates 100% of any unwanted damage. I highly recommend this product for its intended use. If you make sure it’s lined up straight with the pin and don’t use excessive force, this tool will very likely work great for you.

This is exactly what you need if you're building AR lowers! Trying to insert the roll pin for the bolt catch can drive a man to drink. This tool holds the pin securely so you don't have to try with your fingers or pin holders which seldom works out well. Once you have it started, you switch to the other punch to drive it home. The allen wrench keeps the bolt catch aligned properly. The tools are also rubberized to prevent scratches to the lower.

Installing the bolt catch is my least favorite part of putting together a stripped lower. This tool set makes it much easier to do. The punch and starter are the perfect length, so that you aren’t swinging a hammer at awkward angles and a few good strikes will get you roll pin where it should be. They’re covered with a rubber sleeve to prevent marring your lower’s finish. They even come in a little tin, so you don’t lose them! All-in-all, this is a great buy for under $10 if you’re going to be assembling an AR lower any time soon. I would definitely recommend this to anyone who hates installing roll pins as much as I do.

These are great for the occasional builder. I got them for the price and in a pinch. I have already broken the punch (after 15+ builds), but the starter punch should last forever. I'd say it's worth it. Use card stock or 3/5 card cut down in strips. Put the strip and painter tape right up to the hole. Don't go to far with the starter, before switch over to the punch, and go one tap at a time. If you get a small "smiley" mark, bust out and apply Aluminum Black and it'll look perfect.

Best bolt catch roll pin sets sold in America at any price. If you build AR platforms and if you know what you are doing, you own at least one set of these. Seller is fine and shipped next day I think.

This is a must for driving Bolt catch pins. I bought this because I drove the pin slightly too far when I was installing the bolt catch. I couldn't push it back without banging up the lower. I used the punch and was able to push it forward all the way through the other side. One caveat is the you a thin piece of plastic on the magazine side to act as a ramp to avoid marking the hump on the mag well. I used a guitar pick. If you plan on building multiple AR's, buy it!

Makes one of the most annoying parts of building so much easier and quick. If you got big hands this is a god send. Its tough and works flawlessly. If you will build more than 1 system this is a no brainer buy.