6707 Motorcycle Lighting Accessory: Tour-Pak Lid Light, Rear LED Running/Turn Signal/Blinker/Brake Lights for 2014-19 Harley-Davidson Motorcycles, Satin Black

The instructions are clearly written, the wiring is flawless, the finished look is great and the lights perform flawlessly. It took less than an hour to complete. I installed this light on my after-market tour pack and it fit perfectly. However, I did not use the stick-on, zip tie clips, but merely routed the wire from the light under the passenger backrest, then zip-tied it to the tour pack bracket (leaving sufficient length to allow the lid to open without binding), and then routed it under the seat. I also wrapped some electrical tape around the un-insulated 1/2” of wires at the light fixture. I’m very pleased with this addition to my 2019 SG.

I love this! Added tail light for safety! And it is mounted higher for MORE VISIBILITY! Running light, Brake light and Turning signals ALL in one. Worth the money and very easy to install.

Great product. Do yourself a favor & wire inside tour pack unless u wanna mess with it every time u open & close it. Ran through a piece of tubing to keep from getting pinched in lid

Fits aftermarket slim tour pack perfectly. Very bright LED lights. Plug and play on my 2020 Road Glide. No wiring harness needed. Much safer than the stock rear fender lights alone.

The light looks and functions great. No drilling. Fits with or without luggage rack. Chrome luggage rack with increase visibility with reflection. Will fit aftermarket your packs as long as you have that center depression. I even installed one on a heritage after market tour pack, just have to have my local independent shop wire an adapter.

Item arrived early, good quality and easy to install. Attractive as advertised with a very bright display. Adds a nice safety touch to my HD!

Once you de pin the connector and drill a small hole behind the light and then out the bottom of the tour pack. Install is super easy and light is super bright

Great piece . Next day delivery, plug and play... I was multitasking on other stuff. I did no drilling, * my preference* Maybe 1/2 hour to put on if I stayed on task. Looks good That 3M tape. Its not coming off. Lol. I hope this help if you were like me undecided. 4 stars. Only because I had to put it on.🤣

This product is great. Instal could have been done in 20 mins but I triple check everything. LED's look like stock on the back of my 2014 Limited. Things to make application easier . Loosen back left and right luggage rack, only need about 1/2 inch to lift to slide light in will make your life much easier Wiring routing is easy especially the Y they give you. At the pitch point if you feel potential for pinching add another cable holder just to push the wire out of the way( you will understand once you are done) Lights are break ,turn , running and flashers . One more thing the tape is strong make sure you line it up properly. once on you don't want to be playing with it .

Very easy install. I ran my wire into the trunk lid. I drilled a small hole into the lid, after running the wire through, the light itself covered up the hole once sticking the light on. I just hooked up the running and brake lights only,, it is a perfect light up top to aid in perfect eye level visibility to motorists behind me. The light is very bright and the brake light is awesome bright. I recommend this product,, not only for great looks but for additional safety.

Très bon produit