1/2 NPT Ball Valve, Weldless 304 Stainless Bulkhead for Home Brew Kettle

I used this to convert a home depot water cooler to a mash tun. I did need to buy a female 1/2 npt adapter for the inside barb fitting. I didn't use the nut as is took up too much space on the nipple, but the female adapter was able to hold the washer in place to seal the o-ring. Tested at 190 degrees, no leaks. Only 1/3 of a quart of dead space at the bottom with the false bottom I used. Definitely recommend.

Excellent kit with all necessary parts for my Gott cooler. Leaked at first but this was solved by using the supplied Teflon tape on inside as well as outside threads. I used the supplied silicone washers on both inside and outside against the cooler surface.

Like many, I had serious leaking at first. In the end, I put tons of Teflon on all threads, a gasket on each side of the kettle wall, and boom. No leaking. I didn’t have to run to the store, although I nearly threw the towel in. But after using the Teflon I had zero problems.

Prior to this purchase I was at first not sure due to some of the reviews. Then after looking at some of the pictures and re-reading the reviews in question that had pictures, all I have to say is those folks cannot follow simple instructions. YES you have to use the Teflon tape and I recommend wrapping at least 4/5 times. In addition the silicone washer goes on the INSIDE, not the outside. Use two adjustable wrenches when building too, don’t worry about over tightening, yet do not put HeMan strength into it. I did not put Teflon tape on the inside, since that’s why there is the silicone washer, also for sanitary reasons to clean. Lastly I am very satisfied with this purchase, for it saved me a ton of cash not having to purchase a pre made wort chiller and separator that goes for up to 250 dollars. Also first time filling with water it DID NOT LEAK.

special food grade valve.

I had as little trouble with it's leaking at first but was able to stop the leak and it's worked flawlessly since. Going to buy another for a different brew kettle.

We bought this for our water pipe. Works great

This is not a bulkhead fitting. It is a close nipple with a couple washers and a nut. It may work for some situations but just be aware that it is in fact not a true bulkhead fitting as was advertised.

Good quality all in stainless

Well made does the job requied for

Installed on my deep fryer, takes the temp well, easy install.

I got this for homebrew. I usually make large batches of Mead a few times a year and using a label or pot to move the brew was a pain. So I decided to add this to my largest cooking pot. If it was good I was also thinking of replacing the old ball valve tap I had on the oak barrel. This is a good bit of kit. It's modular and gives you lots of choice to change later down the line. The weldless bulkhead is great for attaching to pots or odd shaped barrels. Just make sure you have access to the inside to tighten it properly.they include spare silicone seals which is a huge plus and makes life easier. It is stainless steel and easy to clean, it should also resist any rust for a long time. The tap uses a ball valve so no need to worry about rubber degrading. They're also food safe and VERY reliable. So no drips or leaks. The barbed end is a plus as you can attach a hose easily for draining off and because it is modular you could also change to a different fitting. Good quality and value. Highly recommended. Thank you for reading my review. I hope you found it useful

I needed this at work to make a water barrel out of an old 200l oil barrel for the jet wash. I drilled a hole in the side of it and used all the sealing washers provided and it works perfect. Brilliant value for money and the build quality is really good