Push-On Pushnut, 5/8 Spring Steel, Black, Phosphate & Oil, 2-Piece

Worked fine

Fit perfect and is holding wheels on axle shaft of 2 wheel dolly.

Good product

Great fit but quite expensive

Had a movers dolly with bad wheels. Got them off OK but destroyed the push nuts in the process (very rusty). These worked perfectly and now have serviceable dolly. Went on smoothly with an 11/16 inch socket that I used to tap them on. Did have to buy a couple 5/8 inch flat washers to bring the wheels out to proper place.

I bought a dolly from the local branch of a national hardware chain. When I used it for its intended purpose the wheel fell off. The store did not have these nuts in stock (in fact, their customer service people seemed not to know the name of this nut). Amazon to the rescue! Being naturally cautious, I took a "belt and braces" approach and also used a push-on cap nut for both ends of the dolly axle. Installation hint: use a large socket to make sure the nut goes on straight, and ideally a soft (rubber or resin) hammer. Installation time: 15 seconds!

Exactly what is says it is. Went on as it should and have no problems with it since installing it onto our dolly wheel.

Had to order these twice. The first time, one of the two worked well, the second was loose and easily slipped off the axle. The second order fit well on the same axle, therefore I suspect there is a slight inconsistency in the fit of this product. When they fit, they appear to work ok.